Dell S5000 FTOS 9.0(1.3) Command Line Reference Guide for the Switch - Page 482

Example (VLT) NOTE: The asterisk (*) after the port channel number (Po 2) highlighted in the Example below indicates the port channel is VLT, that the local VLT port channel is down and the remote VLT port is up. FTOS#show ip igmp groups Total Number of Groups: 5 IGMP Connected Group Membership Group Address Interface Mode Uptime Expires Last Reporter 225.0.0.0 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51 Member Ports: Po 2* 225.0.0.1 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51 Member Ports: Po 2* 225.0.0.2 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51 Member Ports: Po 2* 225.0.0.3 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51 Member Ports: Po 2* 225.0.0.4 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51 Member Ports: Po 2* show ip igmp interface View information on the interfaces participating in IGMP. S5000 Syntax Parameters show ip igmp interface [type slot/port] interface type slot/port (OPTIONAL) Enter the interface keyword followed by the interface type and slot/port or number information. Valid slot numbers are 0-11. The valid port numbers for each interface type are listed below. • For a 10-Gigabit Ethernet interface, enter the keyword tengigabitethernet followed by slot/port numbers. The port range is 0 to 63. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by slot/port numbers. The ports are 48, 52, 56, and 60. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For a Port Channel interface, enter the keywords portchannel followed by a number from 1 to 128. • For a VLAN interface, enter the keyword vlan followed by a VLAN id number from 1 to 4094. Command Modes • EXEC • EXEC Privilege 482