Dell Vostro 5481 Service Manual - Page 40

Input output board, Removing the Input and Output board

Get Dell Vostro 5481 PDF manuals and user guides View all Dell Vostro 5481 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

4. Install the: a) battery b) base cover 5. Follow the procedure in After working inside your computer. Input output board Removing the Input and Output board 1. Follow the procedure in Before working inside your computer. 2. Remove the: a) base cover b) battery c) system fan 3. To remove the IO board: a) Peel the adhesive tape that secures the IO board connector [1]. b) Open the IO board connector latch and disconnect IO board cable from the connector on the IO board [2]. c) Disconnect the fingerprint reader cable from the connector on the IO board [3]. NOTE: This step is applicable only to the systems that are shipped with power button with fingerprint reader. d) Remove the two (M2x3) screws that secure the IO board to the palmrest and keyboard assembly [4]. e) Lift the IO board away from the system [5]. Installing the Input and Output board 1. Align and place the IO board to the slot on the palmrest and keyboard assembly [1]. 2. Replace the two (M2x3) screws to secure the IO board to the palmrest and keyboard assembly [2]. 40 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
4.
Install the:
a)
battery
b)
base cover
5.
Follow the procedure in
After working inside your computer
.
Input output board
Removing the Input and Output board
1.
Follow the procedure in
Before working inside your computer
.
2.
Remove the:
a)
base cover
b)
battery
c)
system fan
3.
To remove the IO board:
a)
Peel the adhesive tape that secures the IO board connector [1].
b)
Open the IO board connector latch and disconnect IO board cable from the connector on the IO board [2].
c)
Disconnect the fingerprint reader cable from the connector on the IO board [3].
NOTE:
This step is applicable only to the systems that are shipped with power button with fingerprint reader.
d)
Remove the two (M2x3) screws that secure the IO board to the palmrest and keyboard assembly [4].
e)
Lift the IO board away from the system [5].
Installing the Input and Output board
1.
Align and place the IO board to the slot on the palmrest and keyboard assembly [1].
2.
Replace the two (M2x3) screws to secure the IO board to the palmrest and keyboard assembly [2].
40
Removing and installing components