Dell W-Series 277 Instant 6.5.1.0-4.3.1.0 User Guide - Page 210
More > DHCP Server, DHCP Server, Distributed DHCP Scopes, New DHCP, Scope, New DHCP Scope
View all Dell W-Series 277 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 210 highlights
You can configure distributed DHCP scopes such as Distributed, L2 or Distributed, L3 by using the Instant UI or the CLI. In the Instant UI To configure distributed DHCP scopes such as Distributed, L2 or Distributed, L3: 1. Click More > DHCP Server. The DHCP Server window is displayed. 2. To configure a distributed DHCP mode, click New under Distributed DHCP Scopes. The New DHCP Scope window is displayed. The following figure shows the contents of the New DHCP Scope window. Figure 49 New DHCP Scope: Distributed DHCP Mode 3. Based on the type of distributed DHCP scope, configure the following parameters: Table 44: Distributed DHCP Mode Configuration Parameters Parameter Description Name Enter a name for the DHCP scope. Type Select any of the following options: l Distributed, L2-On selecting Distributed, L2, the VC acts as the DHCP server but the default gateway is in the data center. Traffic is bridged into VPN tunnel. l Distributed, L3-On selecting Distributed, L3, the VC acts as both DHCP server and default gateway. Traffic is routed into the VPN tunnel. VLAN Specify a VLAN ID. To use this subnet, ensure that the VLAN ID specified here is assigned to an SSID profile. For more information on SSID profile configuration, see Configuring VLAN Settings for a WLAN SSID Profile on page 83 and Configuring VLAN for a Wired Profile on page 105. Netmask If Distributed, L2 is selected for the type of DHCP scope, specify the subnet mask. The subnet mask and the network determine the size of subnet. 210 | DHCP Configuration Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide