Dell Wyse 3020 Monitor mount for 2017 P-series monitors Installation guide - Page 11

4 Mounting Wyse 3010, Wyse 3020, Wyse 3030, Wyse 3030LT, and Wyse 5030 clients Use the following instructions to mount the Wyse 3010, Wyse 3020, Wyse 3030, Wyse 3030LT, and Wyse 5030 clients to the P mount. These clients require mounting of the client to their respective horizontal stands before installing the thin client to the P-series monitor mount. Horizontal stands required by thin client model are: Table 1. Client name and part number Client name Wyse 3010 Wyse 3020/5030 Wyse 3030/3030LT Part number XXJ7P 92GX5 GYTXN 1 Preparing the client and attaching the power adaptor a If the thin client is installed on the horizontal stand, remove it from the stand. On the inside of the horizontal stand, slide one of the four hex nuts which come with the tool kit into one of the four screw holes. b From outside of the horizontal stand, insert a shoulder screw into the hex nut and tighten it. c Repeat for remaining three hex nuts and shoulder screws. d Insert the client into the horizontal stand, with the power button facing upward, and the extended plastic ledge on the opposite side. e To install the power adapter holder, slide the small hooks downward into the vertical slotted holes and the large hooks onto the top edge of the mount. Use the M2.5x0.45 screw to secure the power adapter holder onto the mount as indicated in the following illustration. Mounting Wyse 3010, Wyse 3020, Wyse 3030, Wyse 3030LT, and Wyse 5030 clients 11