Dell XPS 15 9500 Service Manual - Page 13

damage to the pins.

Get Dell XPS 15 9500 PDF manuals and user guides View all Dell XPS 15 9500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Steps 1. Remove the eight screws (M2x3) that secure the base cover to the palm-rest and keyboard assembly. CAUTION: Do not pull on or pry the base cover at the side where the hinges are located; doing so may damage the base cover. CAUTION: The base cover is preassembled with the audio-daughter board. The pins at the bottom of the base cover are fragile. They ground the antennas and audio-daughter board. Place the base cover on a clean surface to avoid damage to the pins. 2. Starting from the bottom-left corner, use a plastic scribe to pry the base cover in the direction of the arrows to release the base cover from the palm-rest and keyboard assembly. 3. Grasp the left side and the right side of the base cover and remove the base cover from the palm-rest and keyboard assembly. NOTE: The following steps are applicable only if you want to further remove any other component from your computer. Removing and installing components 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
Steps
1.
Remove the eight screws (M2x3) that secure the base cover to the palm-rest and keyboard assembly.
CAUTION:
Do not pull on or pry the base cover at the side where the hinges are located; doing so may damage the
base cover.
CAUTION:
The base cover is preassembled with the audio-daughter board. The pins at the bottom of the base cover
are fragile. They ground the antennas and audio-daughter board. Place the base cover on a clean surface to avoid
damage to the pins.
2.
Starting from the bottom-left corner, use a plastic scribe to pry the base cover in the direction of the arrows to release the base cover
from the palm-rest and keyboard assembly.
3.
Grasp the left side and the right side of the base cover and remove the base cover from the palm-rest and keyboard assembly.
NOTE:
The following steps are applicable only if you want to further remove any other component from your
computer.
Removing and installing components
13