Denon 4306 Owners Manual - Page 33

Basic Operation 2 Selecting the analog mode Press the ANALOG button on the main unit or INPUT MODE button on the remote control unit to switch to the analog input. ANALOG (exclusive analog audio signal playback mode): The signals input to the analog input terminals are decoded and played. NOTE: • Input mode when playing DTS sources: Noise will be output if DTS-compatible CDs or LDs are played in the "ANALOG" or "PCM" mode. When playing DTS-compatible sources, be sure to connect the source component to the digital input terminals (OPTICAL/COAXIAL) and set the input mode to "DTS". 2 Input mode display • In the AUTO mode Depending on the input signal. • In the DIGITAL PCM mode • In the DIGITAL DTS mode • In the ANALOG mode • In the EXT.IN mode 2 Input signal display • DOLBY DIGITAL • DTS Depending on the input signal. • The "DSD" indicator lights when the DENON LINK have been connected and the DSD signals have been input ( page 19). Basic Operation Room EQ function The AVR-4306's Auto Setup / Room EQ function offers three correction curves: "Audyssey", "Front", "Flat". The timbre of the speakers can also be adjusted manually using a graphic equalizer. Details of the different correction curves are described below. Press the ROOM EQ button. • PCM Depending on the input signal. • The "HDCD" indicator lights when digital signals are being input with a player that supports HDCD playback. The "DIG." indicator lights when digital signals are being input properly. If the "DIG." indicator does not light, check whether the "Digital In Assign" ( page 67) and connections are correct and whether the component's power is turned on. AL24 processing is activated when PCM signals are played while the surround mode is set to PURE DIRECT, DIRECT, STEREO, MULTI CH PURE DIRECT, MULTI CH DIRECT or MULTI CH IN. NOTE: • The "DIG." indicator will light when playing CD-ROMs containing data other than audio signals, but no sound will be heard. • The "Audyssey" is selected, the MultEQ XT indicator lights green. • The "Front" or "Flat" is selected, the MultEQ XT indicator lights red. The MultEQ XT indicator also lights red if the "Speaker Configuration", "Distance", "Channel Level" or "Crossover Frequency" is set manually after conducting the Auto Setup procedure. The Room EQ switches as follows each time the ROOM EQ button is pressed. OFF Audyssey Front Flat Manual Audyssey: This adjusts the frequency response of all speakers to correct the effects of room acoustics. Front: This adjusts the characteristics of each speaker to the characteristics of the front speakers. Flat: This the frequency response of all speakers flat. This is suitable for multi-channel music reproduction, from discrete music sources such as Dolby Digital 5.1, DTS, DVDAudio and Super Audio CD. Manual: Selects the setting value that was set in the Manual EQ Setup. For details of the "Setting the Manual EQ Setup" ( page 75). • The "Audyssey", "Front" and "Flat" Room EQ curves can be selected after performing the Auto Setup procedure. 28