Denon AVP-A1HDCI Owners Manual - English - Page 106

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting GXM Satellite RadioH Symptom "LOADING" is displayed in the XM mode. "NO SIGNAL" is displayed in the XM mode. Cause Countermeasure • The XM Mini-Tuner is acquiring • This message should disappear audio or program information in a few seconds in good signal from the XM satellite signal. This conditions. If you see this message can also occur in weak message often, reposition the XM signal conditions. (Note XM antenna for better signal that the AVP-A1HDCI may not reception. respond to some buttons for XM while this message is displayed.) • The XM Mini-Tuner is not • Check for antenna obstructions receiving the XM satellite signal. and reposition the XM antenna Something may be blocking to get better signal reception. the XM antenna's view of the See instructions supplied with satellites or the antenna is not the XM Mini-Tuner and Dock for properly aimed. antenna installation information. "OFF AIR" is displayed in the XM mode. "UP DATING" is displayed in the XM mode. "XM - - - " is displayed in the XM mode. • You selected an XM channel is • Check back later; in the mean not currently broadcasting. time, select another channel. • You selected an XM channel that • Consult the latest channel guide is blocked or cannot be receive at www.xmradio.com for the with your XM subscription current list of channels. For package. information on receiving this channel, visit www.xmradio.com or contact XM Satellite Radio at 1-800-967-2346. • The selected channel is not • Consult the latest channel guide available. The channel may have at www.xmradio.com for the been reassigned to a different current list of channels. For cases channel number. This message of a new radio or a radio that has may occur initially with a new not received XM's signal for an radio or a radio that has not extended period, allow the radio received XM's signal for an to receive the XM satellite signal extended period. for at least 5 minutes and then try to select the channel again. Page 60 60 59, 60 - - Specifications n Audio section • Analog Input sensitivity / Input impedance: RCA Pre output (unbalanced) : 200 mV / 47 kΩ/kohms XLR Pre output (balanced) : 400 mV / 100 kΩ/kohms Frequency response: 10 Hz ~ 100 kHz +1, -3 dB (DIRECT mode) S/N: 102 dB (IHF-A weighted, DIRECT mode) Distortion: 0.005 % (20 Hz ~ 20 kHz) (DIRECT mode) Rated output: RCA Pre output (unbalanced) : 1.2 V XLR Pre output (balanced) : 2.4 V • Digital D/A output: Rated output - 2 V (at 0 dB playback) Total harmonic distortion - 0.005 % (1 kHz, at 0 dB) Dynamic range - 110 dB Digital input: Format - Digital audio interface • Phono equalizer (PHONO input - REC OUT) Input sensitivity: 2.5 mV RIAA deviation: ±1 dB (20 Hz to 20 kHz) S/N: 74 dB (A weighting, with 5 mV input) Rated output: 150 mV Distortion factor: 0.03 % (1 kHz, 3 V) n Video section • Standard video connectors Input / output level and impedance: Frequency response: • S-Video connectors Input / output level and impedance: Frequency response: • Color component video connector Input / output level and impedance Frequency response: 1 Vp-p, 75 Ω/ohms 5 Hz ~ 10 MHz - +0, -3 dB (when video convert set to "OFF") Y (brightness) signal - 1 Vp-p, 75 Ω/ohms C (color) signal - 0.286 Vp-p, 75 Ω/ohms 5 Hz ~ 10 MHz - +0, -3 dB (when video convert set to "OFF") Y (brightness) signal - 1 Vp-p, 75 Ω/ohms PB / CB signal - 0.7 Vp-p, 75 Ω/ohms PR / CR signal - 0.7 Vp-p, 75 Ω/ohms 5 Hz ~ 100 MHz - +0, -3 dB (when video convert set to "OFF") n Tuner section Receiving Range: Usable Sensitivity: 50 dB Quieting Sensitivity: S/N (IHF-A): Total harmonic Distortion (at 1 kHz): [FM] (note: µV at 75 Ω/ohms, 0 dBf = 1 x 10-15 W) 87.5 MHz ~ 107.9 MHz 1.0 µV (11.2 dBf) MONO 1.6 µV (15.3 dBf) STEREO 23 µV (38.5 dBf) MONO 77 dB STEREO 72 dB MONO 0.2 % STEREO 0.3 % [AM] 520 kHz ~ 1710 kHz 19 µV 103