Denon AVP-A1HDCI Owners Manual - English - Page 44

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting k Trigger Out 1 Select the conditions to turn on the trigger out 1 with respect to the zone, input source, surround mode, HDMI monitor, etc. For details about the trigger out function, see page 23. l Trigger Out 2 This sets the conditions to turn on the trigger out 2, in the same way as "Trigger Out 1" above. A0 Trigger Out 3 This sets the conditions to turn on the trigger out 3, in the same way as "Trigger Out 1" above. A1 Trigger Out 4 This sets the conditions to turn on the trigger out 4, in the same way as "Trigger Out 1" above. [Selectable items] ON - - - Setting with Respect to the Zone When the power of the zone turned on/off, the trigger out turns on. Setting with Respect to the Input Source When the input source set to on is selected, the trigger out turns on. Associated with respect to the input source for zones set to "ON" at "Setting with Respect to the Zone". Setting with Respect to the Surround Mode When the surround mode set to on is selected, the trigger out turns on. This is effective when the "MAIN ZONE" has been set to "ON" for the "Setting with Respect to the Zone" and the input source which is set to "ON" has been selected for the "Setting with Respect to the Input Source". Setting with Respect to the Monitor When the HDMI monitor set to on is selected, the trigger out turns on. This is effective when the "MAIN ZONE" has been set to "ON" for the "Setting with Respect to the Zone" and the input source which is set to "ON" has been selected for the "Setting with Respect to the Input Source". A2 Transducer Setup Set when using transducer. The Transducer Setup can be accessed through GUI menu "Speaker Setup" - "Subwoofer Setup" is "1SP", "2SP L/R" or "2SP MIX". The transducer signal is outputted from "SW3". Level [Variable range] -12dB ~ 0dB ~ +12dB : Set the transducer level. OFF : Turn the transducer output off. When you adjust "Level", the adjusted value is set for all surround modes. To adjust the level for individual surround modes, use "Channel Level" (vpage 72). LPF Set the upper limit of the low frequency output to the transducer. [Selectable items] 40Hz 60Hz 80Hz 90Hz 100Hz 110Hz 120Hz 150Hz 200Hz 250Hz A3 Digital Out Set usage of OPT4 OUT. [Selectable items] ZONE4 Select Rec Select NOTE The ZONE4 operations cannot be performed when set to "Rec Select". A4 Remote ID Set remote control ID. Match the ID setting of the remote control unit and the receiver. [Selectable items] 1 2 3 4 • When changing the remote ID, also change the AMP, iPod, TU and NET/DTU modes of the main remote control unit at the same time (vpage 76). • When changing the remote ID, also change the sub remote control unit at the same time (vpage 81). A5 2Way Remote Set when using the 2-way remote control unit. [Selectable items] Used Not Used When using a 2-way remote control unit (RC-7000CI and RC-7001RCI, sold separately), set this to "Used". NOTE • When using the 2-way remote control unit, connect to the Port 1 RS-232C connector. • If GUI menu "Manual Setup" - "Option Setup" - "2Way Remote"is set to "Used", you cannot use port 1 of the RS-232C terminal for the external controller. 41