Denon AVR 2805 Owners Manual - Page 67

[1] Outputting a program source to an amplifier, etc., in a different room (ZONE2 mode) 1 Press the "Power switch" button. 3, 5 (Main unit) 2 Press the ZONE2/REC button. The display switches as follows each ZONE 2 / REC SELECT time the button is pressed. (Main unit) ZONE2 RECOUT 3 FUNCTION With "ZONE2 SOURCE" displayed, turn the FUNCTION knob and select the source you wish to output. • The display switches the selected source. (Main unit) 4 Start playing the source to be output. • For operating instructions, refer to the manuals of the respective components. 5 FUNCTION To cancel, turn the function knob and select "SOURCE". 21 FUNCTION ZONE2 SOURCE NOTES: • The signals of the source selected in the ZONE2 mode are also output from the VCR-1, VCR-2 and CDR/TAPE recording output jacks. • Digital signals are not output from the ZONE2 audio output jacks. • Refer to page 65, 66 about the MULTI ZONE connections. (Main unit) [2] Remote control unit operations during multi-source playback (selecting the input source) This operation is not possible in the REC OUT mode. This operation is possible when ZONE2 mode is selected. 1 Select "ZONE2" using the ZONE2 button. (Remote control unit) 2 2 Press the ZONE2 "ON" button. 1 To turn off the ZONE2 mode, press the ZONE2 "OFF" button. (Remote control unit) 3 Press the input source button • The ZONE2 source switches directly. 3 4 The output level of the ZONE2 OUT terminals can be controlled using the VOLUME + and - buttons on the remote control unit. The output level of ZONE2 OUT can be controlled only if ZONE2 vol. level is set (Remote control unit) "Variable" at Zone2 Control in System Setup Menu. (see page 43,44) DEFAULT SETTING (ZONE2 VOLUME LEVEL) : - - - dB (MINIMUM) 5 When the ZONE2 SOURCE function is set to TUNER, the preset channel can be selected using the CHANNEL + and - buttons on the remote control unit. (Remote control unit) The main zone output can be turned on and off with the "MAIN ON/OFF" button. 5 4 67