Denon AVR 3300 Owners Manual - Page 5

ENGLISH 2 INTRODUCTION Thank you for choosing the DENON AVR-3300 Digital Surround A / V receiver. This remarkable component has been engineered to provide superb surround sound listening with AV theater sources such as DVD, as well as providing outstanding high fidelity reproduction of your favorite music sources. As this product is provided with an immense array of features, we recommend that before you begin hookup and operation that you review the contents of this manual before proceeding. TABLE OF CONTENTS z Before Using 5 x Cautions on Installation 5 c Cautions on Handling 6 v Features 6 b Connections 7~14 n Part Names and Functions 15, 16 m Setting up the system 17~28 , Remote Control Unit 29~37 . Operation 37~43 ⁄0 Surround 44~47 ⁄1 DSP Surround Simulation 48~52 ⁄2 Listening to the Radio 52~55 ⁄3 Last Function Memory 55 ⁄4 Initialization of the Microprocessor 55 ⁄5 Troubleshooting 56 ⁄6 Additional Information 57~61 ⁄7 Specifications 62 2 ACCESSORIES Check that the following parts are included in addition to the main unit: x Operating instructions.....1 y Warranty ( for North America model only 1  R6P/AA batteries............2 ‘ AM loop antenna 1 ’ FM indoor antenna...1 € AC plug adapter (for Multiple voltage model only 1 r t y Ž Service station list...........1  FM antenna adaptor........1 u i  Remote control unit (RC-860 1 o 1 BEFORE USING Pay attention to the following before using this unit: • Moving the set To prevent short circuits or damaged wires in the connection cords, always unplug the power cord and disconnect the connection cords between all other audio components when moving the set. • Before turning the power switch on Check once again that all connections are proper and that there are not problems with the connection cords. Always set the power switch to the standby position before connecting and disconnecting connection cords. • Store this instructions in a safe place. After reading, store this instructions along with the warranty in a safe place. • Note that the illustrations in this instructions may differ from the actual set for explanation purposes. • Line Voltage Selection (for multiple voltage model only) * The desired voltage may be set with the VOLTAGE SELECTOR knob on the rear panel, using a screwdriver. * If the VOLTAGE SELECTOR knob does not move smoothly, please contact a qualified serviceman. VOLTAGE SELECTOR 115V 230V 2 CAUTIONS ON INSTALLATION Noise or disturbance of the picture may be generated if this unit or any other electronic equipment using microprocessors is used near a tuner or TV. If this happens, take the following steps: • Install this unit as far as possible from the tuner or TV. • Set the antenna wires from the tuner or TV away from this unit's power cord and input/output connection cords. • Noise or disturbance tends to occur particularly when using indoor antennas or 300 Ω/ohms feeder wires. We recommend using outdoor antennas and 75 Ω/ohms coaxial cables. For heat dispersal, leave at least 10 cm/4 inch of space between the top, back and sides of this unit and the wall or other components. 10 cm/4 inch or more 10 cm/4 inch or more Wall 5