Denon AVR 3300 Owners Manual - Page 55
Last Function Memory, Initialization Of The Microprocessor
UPC - 081757503846
View all Denon AVR 3300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Recalling preset stations • To call out out preset stations from the remote control unit. 1 Watching the display, press the SHIFT button to select the preset memory block. (Remote control unit) 2 Watching the display, press the PRESET UP or DOWN button to select the desired preset channel. (Remote control unit) • Calling out preset stations from the main unit's panel. 1 TUNING PRESET Press the TUNING PRESET button. (Main unit) 2 Turn the FUNCTION knob and select the desired station. ENGLISH START SYSTEM CALL SET CALL DVD VDP 1 2 TV/DBS 4 5 VCR-1 CD 7 8 VCR-2/V.AUX +10 0 RC-860 LEARNED/TX POWER OFF ON / SOURCE TUNER 3 SHIFT PHONO 6 MD / TAPE 9 CHANNEL TV/VCR A / B 1 2 VOLUME DISC SKIP+ SPEAKER DOLBY / DTS SURROUND DIRECT DSP SIMULATION 5CH STEREO INPUT MODE ANALOG STEREO EXT.IN MASTER VOL. AUDIO DECK MD CD MULTI MUTING AVR/AVC VIDEO TUNING DVD TV VDP VCR SYSTEM SETUP SURROUND PARAMETER BAND MODE MEMORY TITLE MENU/GUIDE CH SELECT ENTER SELECT STATUS ON SCREEN DISPLAY RETURN USE/LEARN T.TONE MULTI OUTPUT SET UP (Main unit) 13 LAST FUNCTION MEMORY • This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off. This function eliminates the need to perform complicated resettings when the power is switched on. • The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage when the main unit's power switch is off and with the power cord disconnected. 14 INITIALIZATION OF THE MICROPROCESSOR When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the microprocessor is required by the following procedure. 1 Switch off the unit and remove the AC cord from the wall outlet. (for North America model) Switch off the unit using the main unit's power switch. (for multiple voltage model) 2 Hold the following AUTO button and PCM button, and plug the AC cord into the outlet. (for North America model) Hold the following AUTO button and PCM button, and turn the main unit's power switch on. (for multiple voltage model) 1,2 2 3 Check that the entire display is flashing with an interval of about 1 second, and release your fingers from the 2 buttons and the microprocessor will be initialized. NOTES: • If step 3 does not work, start over from step 1. • If the microprocessor has been reset, all the button settings are reset to the default values (the values set upon shipment from the factory). 55