Denon AVR-4311CI Owners Manual - English - Page 91

Setting items Setting details Height Gain Low : Reduce the front height channel volume. Control the front height Mid : Front height channel sound is output with standard sound volume. channel volume. High : Increase the front height channel volume. PLgz Height Determine whether to use front height channel. Speaker Make settings for the speakers outputting sound when playing back in DENON original surround mode. NOTE "Height Gain" is displayed for the following settings. • When the "Speaker Config." - "Front Height" setting (vpage 96) is set other than to "None". • When surround mode is "PLgz" or the PLgz decoder is used. ON : Audio is output from the front height speaker. OFF : Audio is not output from the front height speaker. NOTE • "PLgz Height" is displayed with the settings listed below. • When the "Speaker Config." - "Front Height" setting (vpage 96) is set to other than "None". • "PLgz Height" cannot be set if the HD Audio source being played includes a front height channel. In this case, the Front height channel is played back without decoding in PLgz mode, using the input signal. Height/Wide : Sound is output from the front height speakers and front wide speakers. Height : Sound is output from the front height speakers. Wide : Sound is output from the front wide speakers. OFF : Sound is not output from the front wide speakers and front height speakers. Subwoofer Att. Attenuate subwoofer level when using EXT. IN input. Subwoofer Turn subwoofer output on and off. Effect Switch effect signal for multi-surround speakers on and off. NOTE Only speakers that are set to something other than "None" in "Speaker Config." (vpage 95) can be selected. ON : Set. OFF : Do not set. Usually use in this mode. Set this to "ON" if the subwoofer channel level seems too high when playing audio signal. ON : The subwoofer is used. OFF : The subwoofer is not used. NOTE This can be set when the surround mode is "DIRECT" (vpage 52) and the "Subwoofer Mode" (vpage 96) is "LFE+Main". ON : Create a wider sound stage. OFF : The effect is not set. AUDIO/VIDEO ADJUST Setting items Effect Level Adjust effect signal level. Room Size Determine size of acoustic environment. 1 - 15 (10) Setting details Set to a lower level if the positioning and sense of phase of the surround signals seems unnatural. Medium : Simulate acoustics of a medium room. Medium-large : Simulate acoustics of a medium-large room. Large : Simulate acoustics of a large room. Small : Simulate acoustics of a small room. Medium-small : Simulate acoustics of a medium-small room. NOTE "Room Size" does not indicate the size of the room in which sources are played. Default The "Surround Parameters" settings are returned to the default settings. Yes : Reset to the defaults. No : Do not reset to the defaults. nnTone Adjust the tonal quality of the sound. Setting items Setting details Tone Control ON : Allow tone adjustment (bass, treble). Set the tone control function OFF : Playback without tone adjustment. to ON and OFF. "Tone Control" can be set when "Dynamic EQ" (vpage 89) and "Dolby Volume" (vpage 91) are set to "OFF". NOTE • "Tone Control" settings are not reflected to ZONE2 and ZONE3. • The tone cannot be adjusted in the direct mode. Bass -6dB - +6dB Adjust low frequency range (bass). "Bass" can be set when "Tone Control" is set to "ON". Treble -6dB - +6dB Adjust high frequency range (treble). "Treble" can be set when "Tone Control" is set to "ON". 88 Remote control operation buttons Move the cursor (Up/Down/Left/Right) Confirm the setting Return to previous menu