Denon AVR 889 Owners Manual - English - Page 53
Checking the SIRIUS Signal Strength, and Radio ID, Presetting Radio Channels, Preset Memory, - firmware
UPC - 883795000628
View all Denon AVR 889 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifications ENGLISH • The channel switches continuously when TUNING is pressed and held. • The song title, artist name, composer name, category and reception level can be checked by pressing . • The time (default : 30 sec) for which the on-screen display are displayed can be set at menu "Manual Setup" - "Option Setup" - "On-Screen Display" (vpage 29). Press uio p to return to the original screen. Presetting Radio Channels (Preset Memory) Your favorite broadcast channels can be preset so that you can tune them in easily. Up to 56 channels can be preset. 1 Tune in the broadcast channel you want to preset. 2 Press [MEMORY]. Searching Categories 1 Press [o p]. SR001 Hits 1 CAT : Pops Channel category 2 Use [o p] to select the category, then use [ui] to select the desired channel. Checking the SIRIUS Signal Strength and Radio ID 1 Either turn or press [SAT TU 1/2] to select "SIRIUS". 2 Press until "SIGNAL" appears on the display. The display will switch as shown below, depending on the reception conditions. Display EXCELLENT GOOD WEAK NO SIGNAL Status Signal strength is excellent Signal strength is good Signal strength is weak No signal 3 Adjust the position of the antenna until "SIGNAL: EXCELLENT" is shown on the display. 4 Press until the channel you want to check (example: "SR001") is displayed. 5 Press TUNING and select channel 0 (SR000). Channel No. and Sirius ID are alternately shown on the display. SR000 SiriusID Radio ID b Write your own SIRIUS ID for storage use. Sirius ID : 3 Press SHIFT to select the block (A to G) in which the channel is to be preset. 4 Press or [CHANNEL +/-] to select the preset number (1 to 8). 5 Press [MEMORY] again to complete the setting. To preset other channels, repeat steps 1 to 5. NOTE Preset channels are erased by overwriting them. Listening to Preset Channels 1 Press SHIFT to select the memory block (A to G). 2 Press or [CHANNEL +/-] to select the desired preset channel (1 to 8). • "UPDATING" is displayed while the encording code is being updated. • "SIRIUS UPDATING" is displayed when updating SIRIUS tuner firmware. • Refer to "Troubleshooting" - "SIRIUS Satellite Radio" regarding other messages (vpage 73). Parental Lock 1 Tune to the channel you want to lock. 2 Press [ENTER] for at least 3 seconds. "Code: [ ]" is displayed. 3 Enter the 4-digit lock code using uio p. When you enter the correct code, the corresponding channel is locked. 4 Press [ENTER]. • C hannels under Parental Lock cannot be tuned in by performing Tuning Up/Down or by category search. • C hannels stored in preset memory can be tuned in by the preset channel select operation, even if Parental Lock is applied. • W hen a channel to which Parental Lock is applied is being played, Parental Lock for that channel is cancelled by performing Step2. • S ee "Edit Lock Cord" (vpage 35) for the method of changing Parental Lock Cord. • Y ou can also set "Parental Lock" from the menu (vpage 35). The strength of both the SIRIUS and terrestrial signals can be checked at menu "Input Setup" - "Antenna Aiming" (vpage 35). 50