Denon AVR-890 Owners Manual - English - Page 29
Check Audyssey Auto Setup, Measurement Results Parameter Check - auto setup problem
UPC - 883795000925
View all Denon AVR-890 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Getting Started Connections Settings Playback Multi-Zone Remote Control Information Troubleshooting Specifications ENGLISH Making the Optimum Settings for the Connected Speakers Automatically (Audyssey™ Auto Setup) Error Messages If Audyssey Auto Setup could not be completed due to speaker installation, the measuring environment, etc., an error message is displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again. NOTE Be sure to turn the power off before checking the speaker connections. Error messages (examples) AUTO SETUP AUDYSSEY AUTO SETUP MultEQ Caution! No microphone or Speaker Cause • Included setup microphone is not connected. • Not all speakers could be detected. • The front L speaker was not properly detected. Measures • Connect the included setup microphone to the SETUP MIC jack on the main unit. • Check the speaker connections. Check Audyssey Auto Setup Measurement Results (Parameter Check) This is displayed after Audyssey Auto Setup is completed. 1 Press ui to select "Parameter Check", then press p or . AUTO SETUP PARAMETER CHECK Speaker Config Check Distance Check Channel Level Check Crossover Check EQ Check Restore Retry Check cause of problem! RETURN Cancel Show speaker configuration result Front AUTO SETUP AUDYSSEY AUTO SETUP MultEQ Caution! Ambient noise is too or Level is too low high Retry Check cause of problem! RETURN Cancel AUTO SETUP AUDYSSEY AUTO SETUP Caution! Front R None MultEQ Retry ENTER Enter Check cause of problem! RETURN Cancel AUTO SETUP AUDYSSEY AUTO SETUP Caution! Front L Phase MultEQ Retry Skip ENTER Enter Check cause of problem! RETURN Cancel • Too much noise in the room for accurate measurements to be made. • Speaker or subwoofer sound is too low for accurate measurements to be made. • Either turn off any device generating noise or move it away. • Try again when the surroundings are quieter. • Check the speaker installation and the direction in which the speakers are facing. • Adjust the subwoofer's volume. • Displayed speaker could not be detected. • Check the connections of the displayed · The front R speaker were not properly detected. speaker. · Only one channel of the surround speakers was detected. · Sound was output from the R channel when only one surround back speaker was connected. · The surround back, but the surround speaker was not detected. • Displayed speaker connected with the polarities reversed. • Check the polarities of the displayed speaker. • For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure that the wiring is correct, press ui to select "Skip", then press . 2 Use ui to select the item you want to check, then press p or . Speaker Config. Check : Check the speaker configuration Distance Check : Check the distance Channel Level Check : Check the channel level Crossover Freq. Check : Check the crossover frequency EQ Check : Check the equalizer 3 Use o p to switch the display between the different speakers. 4 Press . The confirmation screen reappears. Repeat steps 2 and 3. Even if the settings are changed after Audyssey Auto Setup, Audyssey Auto Setup settings can be restored by selecting "Restore" then pressing . n To perform Audyssey Auto Setup again Press ui to select "Retry", then press . n To cancel Audyssey Auto Setup Press , the "Cancel auto setup?" prompt is displayed. Press o p and select "Yes", then press . Remote control operation buttons Displaying the menu : Cancel the menu : Moves the cursor (Up/Down/Left/Right) : Decision the setting : Return to previous menu 26