Denon DN-X1100 Owners Manual - Page 11

Getting Started Connections Fader Start Specifications ENGLISH Channel Fader Start 1 Turn the INPUT ASSIGN switch to select the desired source from LINE2, 4, 6 or 8. 2 Turn on the CH FADER START switch. b CROSS FADER ASSIGN position is "THUR". 3 Move the source input fader (Ch. Fader) of CH-1, CH2, CH-3 or CH-4 control all the way to the bottom. 4 Set the standby mode on CD player. 5 Use the CH FADER CONTOUR control to control the channel fader startup curve. 6 When you want to start the player, move up the source input fader (Ch. Fader) and the CD player will begin playing. Source inpCuht afandneerl(Cfahd. eFarder) CH FADER CONTOUR Crossfader Start 1 Turn the INPUT ASSIGN switch to select the desired source from LINE2, 4, 6 or 8. 2 Using the CROSSFADER ASSIGN switch, assign the channel or Sampler source into A or B of Crossfader. 3 Turn on the CROSSFADER START A, B switches. 4 Slide the Crossfader all the way in direction opposite the source you want to start. (In the following example, startup is done with the CD player connected set to Assign A.) 5 Set the standby mode on CD player. 6 Use the CROSSFADER CONTOUR control to control the cross fader startup curve. 7 When the Crossfader is slid in the opposite direction, CD player play will begin. Replacing the Crossfader The Crossfader may be removed without disassembly of DN-X1100 itself. 1 Pull out the Crossfader knob. 2 Removed the five outer screws crossfader plate. attaching the 3 Remove the two screws attaching the crossfader bracket assembly from chassis. 4 Pull the crossfader bracket assembly forward and unplug the 3P cable from the connector on the panel board. CH FADER START CROSSFADER ASSIGN Crossssffaaddeerr CROSSFADER START A CROSSFADER START B CROSSFADER CONTOUR