Denon DN-X1100 Owners Manual - Page 8

Getting Started Connections Fader Start Specifications ENGLISH Rear Panel Power cord U.S.A. and Canada models: To power outlet (AC 120 V, 60 Hz) European models: To power outlet (AC 230 V, 50 Hz) q MAIN OUT (BALANCED) connectors • These XLR type connectors provide a balanced line level output. • Connect these connectors to the balanced analog input connectors on an amplifier or console. • Pin layout: 1. GND, 2. Hot, 3. Cold • Applicable connector: Cannon XLR-3-31 or equivalent. w LEVEL ATT (Master out level attenuator) • Use this to attenuate the MASTER output level (-10 dB). • Reference is 0 dB. e MASTER MONO OUT ON/OFF switch When this switch is on, mixed L and R signal is outputted from the MASTER OUT. r MAIN OUT (UNBALANCED) terminals • This stereo pair of RCA terminals provides a unbalanced line level output. • Connect these terminals to the unbalanced analog input terminals on an amplifier or console. t REC OUT terminals • This stereo pair of RCA terminals provides a line level output. The signal is unaffected by the Master Level control. • It is intended for use with a tape recorder, but is not restricted to that purpose. y BOOTH OUT (BALANCED) connectors • These 1/4" TRS type connectors provide a balanced line level output with independent front panel Zone Level controls and are not affected by the Master Level control. • Connect these connectors to the balanced analog input connectors on an amplifier or console. • Pin layout: Tip: Hot, Ring: Cold, Sleeve: GND • Applicable connector: Cannon XLR-3-31 or equivalent. u SEND/RETURN terminals • These 1/4" TS mono terminals allow external processing of the program signal. • When connect monaural type effect processor, use Lch input and output. i LINE 2, 4, 6, 8 FADER output terminals Connect these terminals to the Fader input terminals of the DN-S1200, DN-S3500, DNHS5500 and etc using the 3.5 mm stereo mini cord. o DUCKING ATTENUATION LEVEL control DUCKING attenuation level can be adjusted. (- ∞ ~ -20 dB) Q0 AUX MIC input terminal Accepts a balanced microphone with 1/4" terminals. Q1 MAIN MIC input terminal • Neutric combo terminal. • Accepts either a balanced microphone with an XLR connector or a balanced microphone with 1/4" TRS balanced terminals. Q2 PHONO 1, 2, 3 /LINE 1, 3, 5 switches • These switches change the Input from Phono to Line level inputs. • These switches set Line level inputs when Turntable is not connected. Q3 PHONO 1, 2, 3 /LINE 1, 2, 3, 4, 5, 6, 7, 8 input terminals These stereo pairs of unbalanced RCA terminals are Inputs for any line level device. Q4 Phono Ground screws This screws provide a place to connect the ground wire from a turntable. This terminal is exclusively for a turntable grounding and not a safety earth ground.