Denon DN X1700 Owners Manual - Page 7
Part Names and Functions - midi
UPC - 883795000864
View all Denon DN X1700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Getting Started Connections Basic Operations Effector Function Fader Start USB Utility Specifications Troubleshooting Part Names and Functions For further details on the functions and other aspects of the parts, refer to the page numbers in parenthesis. Top Panel E1 E3 E2 E5 R1 R2 R3 q w E0 e W9 r W8 t y E4 W7 E6 E7 W6 E8 W5 u W4 i o W3 Q0 W2 Q1 W1 W0 Q2 Q3 Q9 Q4 Q8 Q5 R0 Q7 Q6 E9 q MASTER LEVEL control Adjusts the level of the MASTER outputs. The LIMITER LED indicates the operating status of the master output limiter. • Limiter OFF: LED is off. • Limiter ON: LED lights up green. • While limiter is operating: LED lights up red. w Master EFX INS 1, 2 buttons These buttons enable the various effects of the selected side, either EFX 1 or EFX 2, to be obtained for the master output signals. e BOOTH LEVEL control Adjusts the level of the BOOTH outputs. r USB ASSIGN CH/MASTER button This is used to switch the assignment destination of the USB audio input signals supplied from the computer. CH: The signals are assigned to the channels (1 to 4). MASTER: The signals are assigned to the master bus and monitor bus. t MIDI CLOCK START/STOP button This enables the MIDI clock corresponding to the BPM value to be sent from the USB MIDI and MIDI output terminals to the computer (software) or external device. START: Sending the MIDI clock is started. STOP: Sending the MIDI clock is stopped. y UTILITY/-USB A/USB B button This allows the presets to be set and the system information to be set, changed or referenced. When it is held down for more than a second, the USB mode switching screen is opened, and the USB device mode or USB host mode can be selected. u BEAT , buttons (Short) : The beat/time is decreased. (Long) : The beat/time is increased. i TAP LOCK/AUTO/INPUT BPM button TAP: When this button is tapped repeatedly, the BPM (Beats Per Minute) value is measured using the intervals between the taps. LOCK: When the button is pressed once in the auto BPM mode, the BPM value measured automatically is locked. AUTO BPM: When the button is held down for one second, the auto BPM mode is established, and the measured BPM value is displayed. INPUT BPM: When it is held down for two or more seconds, the BPM input mode is established, and the BPM value can be input directly using the u BEAT , buttons. When it is pressed again, the mode is released. o TIME/BACK button TIME: This button is used to select whether to change the effects produced using the u BEAT , buttons on the basis of the number of beats or time. BACK (EFX 2 side only): This is used when returning to the previous screen while setting screen operations are being performed. Q0 Effect CUE button When this button is set to ON, the sound of the effects (but not the DELAY, ECHO or REVERB effects) can be monitored even if the effect OFF status. Q1 EFX SELECT control This is for selecting the effect to be used. Refer to the effect functions (page 9). Q2 Parameter ON/OFF button This is used to control the ON and OFF settings of the effect parameters. Q3 PARAMETER MIX/MAX control This is used to adjust the filter cutoff frequency and other effector parameters. The parameters are changed by the effector selected. Q4 DRY/WET control Use this to adjust the ratio of original and effected sound. 3