Dewalt DCF6201 Instruction Manual - Page 6
Setting Magazine Screw Length Fig. 5, Proper Hand Position Fig. 3
View all Dewalt DCF6201 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
English Proper Hand Position (Fig. 3) WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand positions as shown in Figure 3. Proper hand position requires one hand on the rear grip. Take care to not block the air vents on the screwgun. FIG. 3 CAUTION: NEVER grip the collated attachment, use it as a handle or touch the screw strips while in operation as shown in Figure 4. FIG. 4 Setting Magazine Screw Length (Fig. 5) This magazine is designed for 1"- 2" (20- 50 mm) screw lengths. Failure to set the correct screw length can cause screws to not be driven accurately which can result in the failure to advance to the next screw or screws not being driven properly. The shoe has marked specific slots for each of the most common screws, however this attachment can still drive any size screw between 1"- 2" (20- 50 mm). To accommodate for less common screws adjust to the next longest slot. CAUTION: Do not adjust while a screw strip is in the magazine. FIG. 5 1. Slide screw length adjustment tab (B) to the left. B E 2. Holding the screw length adjustment tab in place, adjust the shoe (E) to the desired length. 3. Release the screw length adjustment tab. Make sure that the locking pin has fully returned and is in the correct position. 4 Page dimensions: 8.5 x 5.5