Dewalt DWE74911 Instruction Manual - Page 7

English WARNING: Be sure that the locking pins have engaged and the legs are firmly held in place. 4. With all legs locked in their open positions, pull stand toward you and tilt over until all four feet are on the ground. Transporting the Saw on the Stand (Fig. 7) COLLAPSING THE STAND FOR TRANSPORT 1. Lifting the stand by the handle, tilt up the stand until the saw is at a 90 degree angle sitting on the kickstand. 2. Fold the handle-side legs by depressing the handle-side leg release levers (C) and rotate until locking pin clicks into the detent (O). Repeat the operation on the second handle side leg of the stand. 3. Fold the wheel-side legs by rotating the wheel-side leg release levers (D) with foot (or hand) and rotate until locking pin clicks into the detent (O). Repeat with other wheel leg. WARNING: Be sure that the locking pins have engaged and the legs are firmly held in place. FIG. 7 OD O C WARNING: To reduce the risk of personal injury, DO NOT operate the table saw mounted to the stand with the legs folded and the stand sitting on the ground. MAINTENANCE WARNING: To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury. Cleaning WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once a week. To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye protection when performing this. WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. These chemicals may weaken the plastic materials used in these parts. Use a cloth dampened only with water and mild soap. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid. Accessories WARNING: Since accessories, other than those offered by DEWALT, have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, only DEWALT recommended accessories should be used with this product. Recommended accessories for use with your tool are available at extra cost from your local dealer or authorized service center. If you need assistance in locating any accessory, please contact DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286, call 1-800-4-DEWALT (1-800-433-9258) or visit our website: www. dewalt.com. 5