Dewalt DXCMLA1682066 Instruction Manual - Page 10
Draining Air Tank under
View all Dewalt DXCMLA1682066 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
English reaches cut-out pressure, the check valve closes, allowing air pressure to remain inside the air tank. AIR INTAKE FILTERS The filters (A) are designed to clean air entering the A pump. To ensure the pump continually receives a clean, cool, and dry air supply the filters must always be clean and the filter intakes must be free from obstructions. AIR TANK DRAIN VALVE The drain valve (H) is located ath the base of the air tank and is used to drain condensation at the end of each use. See Draining Air Tank under Maintenance. H REGULATED PRESSURE GAUGE The regulated pressure gauge (D) indicates the air pressure available at the outlet side of the regulator. This pressure is controlled by the regulator D C and is always less or equal to the air tank pressure. TANK PRESSURE GAUGE The tank pressure gauge (C) indicates the reserve air pressure in the tank. UNIVERSAL QUICK CONNECT BODY L The universal quick connect body (L) E accepts the three most popular styles of quick connect plugs: Industrial, automotive, and ARO. One hand push-to-connect operation makes connections simple and easy. REGULATOR The regulator knob (E) controls the air pressure coming from the air tank. To Adjust Regulator: Turn knob clockwise to increase regulated pressure and counterclockwise to decrease regulated pressure. WARNING: Risk of Bursting. Too much air pressure causes a hazardous risk of bursting. Check the manufacturer's maximum pressure rating for air tools and accessories. The regulator outlet pressure must never exceed the maximum pressure rating. AIR COMPRESSOR PUMP The pump compresses air into the air tank. Working air is not available until the compressor has raised the air tank pressure above that required at the air outlet. MOTOR OVERLOAD PROTECTOR The motor has a thermal overload protector. If the motor overheats for any reason, the overload protector will shut off the motor. The motor must be allowed to cool down before restarting. To restart: 1. Set the Auto/Off switch to OFF (O) and unplug unit. 2. Allow the motor to cool. 3. Depress the red reset button (N) on N the motor. 4. Plug the power cord into the correct branch circuit receptacle. 5. Set the Auto/Off switch to AUTO (-). 10