Dewalt DXCMLA1682066 Instruction Manual - Page 14
Shut-down Fig. 1
![]() |
View all Dewalt DXCMLA1682066 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
English NOTE: After about 30 minutes, If the unit does not operate properly, SHUT DOWN IMMEDIATELY, and contact Product Service. 7. Check all air line fittings and connections/piping for air leaks by applying a soap solution. Correct if necessary. NOTE: Minor leaks can cause the air compressor to overwork, resulting in premature breakdown or inadequate performance. 8. Check for excessive vibration. 9. After 30 minutes, turn the Auto/Off switch to the "Off" position. 10. Close the drain valve. 11. Turn the Auto/Off switch to the "Auto" position. The air receiver will fill to "cut-out" pressure and the motor will stop. The compressor is now ready for use. Before Each Start-Up 1. Place Auto/Off switch to "Off". 2. Close the drain valve. 3. Visually inspect air lines and fittings for leaks. 4. Check safety valve. See To Check Safety Valve under Maintenance. 5. Turn the regulator knob counterclockwise to set the outlet pressure to zero. 6. Attach hose and accessories. WARNING: Risk of unsafe operation. Firmly grasp air hose in hand when installing or disconnecting to prevent hose whip. WARNING: Risk of unsafe operation. Do not use damaged or worn accessories. NOTE: The hose or accessory will require a quick connect plug if the air outlet is equipped with a quick connect socket. WARNING: Risk of bursting. Too much air pressure causes a hazardous risk of bursting. Check the manufacturer's maximum pressure rating for air tools and accessories. The regulator outlet pressure must never exceed the maximum pressure rating. CAUTION: Risk of unsafe operation. Compressed air from the unit may contain water condensation and oil mist. Do not spray unfil tered air at an item that could be damaged by moisture. Some air tools and accessories may require filtered air. Read the ins tructions for the air tools and accessories. How to Start 1. Turn the Auto/Off switch to "Auto" and allow tank pressure to build. Motor will stop when tank pressure reaches "cut-out" pressure. 2. Turn the regulator knob clockwise to increase pressure. IMPORTANT: When using regulator and other accessories refer to the manufacturers instructions. WARNING: Risk of bursting. If any unusual noise or vibration is noticed, stop the compressor immediately and have it checked by a trained service technician. The compressor is ready for use. Shut-down (Fig. 1) 1. Move Auto/Off switch to the OFF position. NOTE: If finished using compressor, follow Steps 2 - 6. 2. Turn the regulator knob counterclockwise until fully closed. Ensure regulated pressure gauge reads 0 psi. 3. Remove hose and accessory. WARNING: Risk of unsafe operation. Firmly grasp air hose in hand when installing or disconnecting to prevent hose whip. 14
![](/manual_guide/products/dewalt-dxcmla1682066-instruction-manual-59a2f0f/14.png)