Dewalt DXCMV7518075 Instruction Manual - Page 15
Shut-down Fig. 1
View all Dewalt DXCMV7518075 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
English 9. After 30 minutes, turn the Auto/Off switch to the "Off" position. 10. Close the drain valve. 11. Turn the Auto/Off switch to the "Auto" position. The air receiver will fill to "cut-out" pressure and the motor will stop. The compressor is now ready for use. Before Each Start-Up 1. Place Auto/Off switch to "Off". 2. Close the drain valve. 3. Visually inspect air lines and fittings for leaks. 4. Check safety valve. See To Check Safety Valve under Maintenance. 5. Attach hose and accessories. WARNING: Risk of unsafe operation. Firmly grasp air hose in hand when installing or disconnecting to prevent hose whip. WARNING: Risk of unsafe operation. Do not use damaged or worn accessories. NOTE: A regulator MUST be installed when using accessories rated at less than 135 psi. NOTE: The hose or accessory will require a quick connect plug if the air outlet is equipped with a quick connect socket. WARNING: Risk of bursting. Too much air pressure causes a hazardous risk of bursting. Check the manufacturer's maximum pressure rating for air tools and accessories. The regulator outlet pressure must never exceed the maximum pressure rating. CAUTION: Risk of unsafe operation. Compressed air from the unit may contain water condensation and oil mist. Do not spray unfiltered air at an item that could be damaged by moisture. Some air tools and accessories may require filtered air. Read the ins truc tions for the air tools and accessories. How to Start 1. Turn the Auto/Off switch to "Auto" and allow tank pressure to build. Motor will stop when tank pressure reaches "cut-out" pressure. 2. When the tank pressure reaches "cut-out" pressure open the globe valve/air discharge valve. IMPORTANT: When using regulator and other accessories refer to the manufacturers instructions. WARNING: Risk of bursting. If any unusual noise or vibration is noticed, stop the compressor immediately and have it checked by a trained service technician. The compressor is ready for use. Shut-down (Fig. 1) 1. Move Auto/Off switch to the OFF position. NOTE: If finished using compressor, follow Steps 2 - 6. 2. Remove hose and accessory. WARNING: Risk of unsafe operation. Firmly grasp air hose in hand when installing or disconnecting to prevent hose whip. 3. Drain the air tank, see Draining Air Tank under Maintenance. Ensure air tank pressure gauge reads 0 psi. WARNING: Risk of bursting. Drain air tank daily. Water will condense in air tank. If not drained, water will corrode and weaken the air tank causing a risk of air tank rupture. 4. Allow the compressor to cool down. 5. Wipe air compressor clean and store in a safe, non-freezing area. 15