Dymo Rhino 1000 Industrial Label Printer User Guide 1 - Page 7

Printing Modes Two print modes are available in addition to Normal: fixed length and flag mode. Pressing NORMAL returns you to normal printing mode. Printing Fixed Length Labels LENGTH Normally, the length of the label is determined by the length of the text entered. However, you may wish to make a label for a specific purpose that is a fixed length regardless of the length of the text. You can specify a fixed length for a label in 0.10" (2 mm) increments between 1.50" (40 mm) and 20.00" (500 mm). The default fixed length is 2.00" (50 mm). Any change you make to the fixed length setting remains in effect until you change it. To set the label length 1. Press LENGTH . 2. Use the arrow keys to increase or decrease the length and press . 3. Press PRINT . When you attempt to print with the fixed length set smaller than the length needed to print the label text, an error message is displayed indicating the minimum allowable length. Printing in Flag Mode FLAG Flag labels wrap around a wire or cable leaving the text part of the label extending out from the cable. See Figure 9. D.01 D.01 U Figure 9 The text on flag labels is automatically printed on both ends of the label leaving a blank space in the middle that wraps around the cable. When the label is applied to the cable, both ends of the label are applied back to back leaving a tail or flag. The result is a label that can be read from both sides. To print a flag label 1. Enter the text for the label. 2. Press FLAG and then press . 3. Press PRINT . Printing Options You can choose to print your labels vertically, print multiple copies of the same label, print serialized labels, or print multiple copies of serialized labels. Printing Vertical Labels VERT Single-line labels can be printed with the text running vertically. To print vertically 1. Enter the text for your label. 2. Press VERT and then use the arrow keys to turn on vertical printing. 3. Press PRINT . Printing Multiple Copies You can print up to 16 copies of the same label at one time. When printing multiple copies, a dotted cut-line is printed between each label. To print multiple copies 1. Press S + PRINT . 2. Press > to increase the number of copies to print. The default is 2 copies. 3. Press < to decrease the number of copies. 4. Press or PRINT to begin printing. You may notice a brief pause in printing between each label for more complex formats. When printing is finished, the number of copies to print returns to 2. 7