Dymo Rhino 1000 Industrial Label Printer User Guide 1 - Page 8
Cleaning Your Printer
View all Dymo Rhino 1000 Industrial Label Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Serializing Your Labels SERIAL When Serial mode is turned on, the right-most number in the label text is increased by one each time you press PRINT . For example, if the label text is RHO-123 and you press print three times, three labels would print as RHO-123, RHO-124, and RHO-125, and the display would show RHO-126 when the last label is printed. To serialize your labels 1. Enter the text for your label including at least one number. 2. Press SERIAL and then use the arrow keys to turn on serial printing. 3. Press or PRINT to begin printing. 4. Repeat step 3 for each additional label in the series. To print multiple copies of the same serialized label, choose S + PRINT and enter the number of copies of each label to print. See Printing Multiple Copies on page 7. Adjusting Print Quality (Advanced) Depending on the label material you choose, you may need to lighten or darken the print on the label. Adjusting the print head temperature allows you to control the print quality (+/- 20). Five temperature settings are available to adjust the print head temperature. The default setting is 3. To adjust the print quality 1. Press S + SPACE followed by PRINT . 2. Use the arrow keys to select the print head temperature and press . 3. Repeat as necessary until you are satisfied with the print quality. Cleaning Your Printer Your printer is designed to give you long and trouble-free service, while requiring very little maintenance. Clean your printer from time to time to keep it working properly. Clean the cutter blade each time you replace the label cassette. To clean the cutter blade 1. Remove the label cassette. 2. Place the tip of a ball-point pen or pencil on the L-shaped piece as shown in Figure 10, and press the piece down. Press in and hold Press Figure 10 3. While holding the L-shaped piece down, press and hold the cutter lever to expose the cutter blade. 4. Use a cotton ball and alcohol to clean both sides of the blade. 5. Release the cutter lever. To clean the print head ➤ Clean the print head using the cleaning tool located inside the label compartment lid. 8