Dynex DX-LTDVD20 User Manual (English) - Page 11

Using basic controls 11 Connecting a computer 1 HDMI INPUT AUDIO PC INPUT VGA PC INPUT 5 3 2 4 6 To connect a computer: 1 Remove the port cover (1) on the back of your TV combo. 2 Plug a VCA cable (2) into the VGA port on the computer (4) and into the VGA INPUT port on the back of your TV combo. 3 Plug a audio cable (3) into the audio jack on the computer (4) and into the AUDIO VGA INPUT port on the back of your TV combo. 4 Turn on your TV combo. 5 Press INPUT and the or to select PC/VGA. Note The best resolution for displaying computer video on your TV combo is 1280 × 768. To connect an HDMI device to the HDMI jack: 1 Remove the port cover on the back of your TV combo (1). 2 Plug an HDMI cable (5) into the HDMI port on the HDMI deivce (6) and into the HDMI INPUT port on the back of your TV combo. 3 Turn on your TV combo. 4 Press INPUT and the or to select HDMI. Using basic controls Turning your TV combo on and off To turn your TV combo on and off: 1 Press POWER on the side of your TV combo or on the remote control. The POWER/STANDBY indicator turns green. 2 To turn off your TV combo, press POWER again. The POWER/STANDBY indicator turns red. Note A small amount of electric power is consumed even when the power is turned off. Adjusting the volume You can adjust the volume using the controls on your TV combo's side panel or the remote control. To adjust the volume: 1 Press VOL+ or VOL- to increase or decrease the volume. 2 Press MUTE to mute the sound, then press this button again to restore the sound. Changing the video mode Your TV combo supports multiple video modes. To select the video mode: • Press INPUT one or more times to select the video mode, then press ENTER. You can select: • TV • AV1 • AV2 • S-Video • Component • DVD • HDMI • VGA Using the TV Selecting the TV signal source To select the TV signal source: 1 Press TV MENU, then press or to highlight the CHANNEL icon. The CHANNEL menu appears. 2 Press to enter the menu. 3 Press or to select Antenna, then press or to select Air or CATV. 4 Air-VHF/UHF channels. 5 CATV-Cable TV channels. 6 Press TV MENU one or more times to close the menu. Changing channels To change channels: • Press the CH+ or CH- on the side of your TV combo or the CH or CH . To enter a channel number directly: • Press the number buttons on the remote control. In digital TV mode, a main (major) channel may have one or more sub (minor) channels. Press the number buttons for the major channel, press the • button (to the left of the 0 button), then press the number button for the minor channel. For example, if you want to watch channel 5-2, press 5, press the • button, then press 2. To go to the previous channel: • Press RECALL.