Dynex DX-LTDVD20 User Manual (English) - Page 4
Features, Accessories, Front - power cord
View all Dynex DX-LTDVD20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
4 Features Outdoor antenna grounding If an outside antenna or cable system is connected to your TV combo, make sure that the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA No. 70, provides information with respect to correct grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of the antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. An outside antenna system should not be located near overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, because contact with them can be fatal. 7 6 5 4 3 1 2 1 Electric service equipment 2 Power service grounding electrode system 3 Ground clamps 4 Grounding conductors 5 Antenna discharge unit 6 Grounding clamp 7 Antenna lead-in wire Note to CATV system installer This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for correct grounding and in particular, specifies that the cable ground must be connected to the grounding system of the building as close to the point of cable entry as practical. Features Accessories Make sure that the following accessories are provided in the packaging: • YPbPr cable • Power cord • Remote control and batteries Front 1 2 3 4 5 6 7 No. 1 2 3 4 5 6 7 8 9 10 11 12 OPEN/ CLOSE PLA Y ST OP DISC IN NEXT PREV 89 CH CH VOL VOL MENU INPUT POWER PHONES INPUT 2 VIDEO L AUDIO R 10 11 12 13 14 Component Description OPEN/CLOSE PLAY STOP Disc IN indicator NEXT PREV Disc slot Power/Standby indicator IR sensor CH+/CH- Volume+/Volume- MENU Press to eject the disc in the disc slot. Press to change to DVD mode and begin disc playback. Press to stop disc playback. When Iit, indicates a DVD or CD is loaded into the disc slot. Press to skip to the next chapter or track. Press to skip to the previous chapter or track. Insert a DVD or CD to change to DVD mode and play the disc. Lights when your TV combo is plugged into a power outlet. When your TV combo is on, the indicator is green. When your TV combo is in standby mode, the indicator is red. Receives signals from the remote control. Do not block. Press to change the channel. Press to adjust the volume. Press to open the TV menu.