Dynex DX-LTDVD20 User Manual (English) - Page 24

24 Troubleshooting TV Problem Solution No picture or sound. Picture is OK, but no sound. Sound is OK, but no color. The picture has overlapped images. Picture has snow. Stripes on picture. Bad stereo or SAP sound. Remote control does not work. Your TV combo displays a black or blue screen. No Signal appears on the screen. Image is not clear. Image is not centered. Check all cable connections. Make sure that your TV combo is turned on. Check the volume level and mute setting. Check the color control and adjust it. Check the program's color features because it may be a black and white movie. Make sure that the antenna is installed correctly. If not, adjust the antenna toward the broadcasting station. Check the antenna and its connection. If there are problems, correct them. If all connections are tight, the problem may be with a faulty antenna or cable. Check car traffic or neon signs that may disrupt the image. Check for interference from other electronic devices, such as radios and televisions, and keep magnetic or electronic devices away from your TV combo. A long distance from the broadcasting station or interference from radio waves can generate bad sound reception. If so, change the mode to Mono. Remove obstacles between the remote control and the player. Point the remote control at your TV combo's IR sensor. Install fresh batteries. Check the resolution and frequency of your computer, and adjust it to the optimum resolution for this TV: 1280 × 768 at 60Hz. Make sure that the cable is firmly connected to the computer and TV. Adjust the phase control. Adjust the horizontal control. DVD player Problem No sound No image Bad sound quality Solution Make sure that your TV combo or amplifier is working correctly. Make sure that the amplifier is set to receive DVD signal output. Make sure that your TV combo is working correctly. Make sure the color system is set correctly. Make sure that the audio output mode is set correctly. Make sure that the audio connection between your TV combo and amplifier (if used) is secure. Troubleshooting Problem Disc cannot be played The player does not operate normally Remote control does not work Solution Make sure that the disc is inserted with the label facing forward. Clean the disc. Moisture has condensed in the player. Remove the disc and leave the player on for about an hour to dry out. Disconnect the power plug, then reconnect it. Remove obstacles between the remote control and the player. Point the remote control at your TV combo's IR sensor. Install fresh batteries. Specifications LCD Dimension Panel Resolution Viewing angle Contrast ratio Brightness (cd/m2) With stand Without stand Weight TV TV standard Tuning system Power Sound Terminals Frequency range Stereo CATV Input Consumption (Max.) Output A/V in Component PC in HDMI Antenna in DVD player Signal System Applicable disc 20" wide TFT LCD 1366 × 768 80°/80°/80°/60° 500:1 500 20.9 × 16.6 × 8.3 inches (534 × 422 × 210 mm) 20.9 × 14.5 × 3.5 inches (534 × 368 × 90 mm) 21.3 lbs. (9.8 kg) NTSC Electronic tuning system VHF/UHF NICAM 125 channels 100-240V AC, 50/60 Hz 75 W 3 W + 3 W Video, S-Video, Audio L/R Y, Pb (Cb), Pr (Cr) D-SUB 15-pin RGB in HDMI compliant (type A connector) F-type NTSC DVD: 12 cm CD: 12 cm