Electrolux E15IM60GPS Complete Owner's Guide (English) - Page 12

12 Door Adjustment Adjusting the Door Your door is aligned at the factory before shipment. Occasional re-adjustment may be necessary, especially if an overlay panel is installed. The following procedure will correct for up to 1/4" alignment. The door should never be flush with the top of the cabinet. Even when level, the top edge of the door will be 1/8" below the top of the cabinet (see Figure 20). To adjust : 1 Compare the top edge of the door (opposite the hinges) to the top edge of the cabinet and note the type of adjustment (up or down) needed. 2 Remove the top hinge pivot pin with a Phillips® head screwdriver (see Figure 21) and lift door off bottom hinge pin. Be careful not to lose door closers (see Figure 23). 3 With door upside-down, loosen but do not remove the two hinge plate screws. 1/8" 4 If door edge opposite the hinges needs to move up, move plate toward outside of door. If door edge needs to move down, move plate toward inside of door (see Figure 22). Repeat until top edge of door is parallel with top of cabinet and tighten screws securely. Figure 22 SLOTTED MOUNTING HOLES NOTCH RAISE OUTSIDE DOOR EDGE LOWER OUTSIDE DOOR EDGE CLRCO001a 5 After adjustment is complete, remove the door closers from the bottom hinge, clean thoroughly and apply petroleum jelly to the mating surfaces of the closers (see Figure 23). Be sure that bosses on closers align with holes in hinge and hinge plate. Mount door and install top hinge pivot pin. Figure 23 Figure 20 Figure 21 DOOR CLOSER INSERTS BOSS UL312