Electrolux E30EW75EPS Installation Instructions - Page 4

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS 4. Cabinet Installation Heavy Weight Hazard • Use 2 or more people to move and install wall oven. • Failure to follow this instructions can result in injury or damage to the unit. The wall oven can tip when the door is open. The mounting brackets supplied with the wall oven must be attached to the cabinet and the appliance to prevent tipping of the wall oven and injury to persons. Mounting Brackets Installation Instructions 1.Unpack the wall oven and find the 2 mounting brackets and screws included in the literature package. 2.Install the mounting bracket in the cabinet as shown on figure 4. Note: To prevent damage to cabinet, it is recommended to drill 1/16" (0.16 cm) dia. pilot holes before installing the mounting brackets. Cutout Dimensions 28 1/2" (72.4 cm) Min.* 29" (73.7 cm) Max.* * Recommended Cutout Width is 28½" (72.4 cm) Mounting Brackets 23 1/4" (59.1 cm) 28 1/4" (71.8 cm) Min. 28 7/8" (73.3 cm) Max. 1 1/2" (3.8 cm) clearance between unit Figure 5 Figure 6 1 Mounting bracket installed 2 3 Oven in cabinet Bracket Figure 4 Oven 3.Insert the unit into the cabinet opening. Slide unit inward leaving 1 1/2" (3.8 cm) clearance between the oven and front of cabinet (see Figure 5). Pull the armored cable through the hole in the floor and toward the junction box while moving the appliance inward. 4.Push the unit in and against the cabinet, then the oven side bracket will clip in the one you just install on the side of the cabinet opening (see figure 6). To pull out the oven for servicing insert the tool supplied with the appliance both side at the same time in the hole located on the side frame and visible when the door is opened. After inserting the tool pull the oven towards you (see figure 7). 5.For typical under counter installation of an electric built-in oven see Figure 8. 4 Cabinet Mounting bracket released Right Side Tool supplied Oven removed from the cabinet Hole where to insert the tool Figure 7