Electrolux E30EW75EPS Installation Instructions - Page 8

Electric Cooktop Installation Over 30" Single Electric Wall Oven For all approved electric cooktop models, cut minimum 4" x 4" opening in right cabinet side panel and/or filler panel, to route armoured cable to junction box Side filler panels necessary to isolate oven from adjoining cabinets. Panel height may need to be modified to accommodate the depth of approved electric cooktop models 240 /208V Junction box for electric cooktop Approx. 3" 240 /208V Junction box for wall oven Cooktop cutout** Approx. 3" 24" min.* 28 1/2" min. 29" max. Oven cutout 36" min. 28 1/4" min. 28 7/8" max. 24" min. cutout depth 4-1/2" maximum height allowed from oven base to floor if cooktop is installed directly over wall oven. (5" maximum height allowed with no cooktop.) Install 3/4" full plywood base on 2 runners, flush with toe plate, capable of supporting 200 lbs. Unit will overlap cutout (minimum) edges by 1" To route armoured cable to junction box through left cabinet side panel and/or filler panel, cut minimum 4" x 4" opening in wood base and runner *Critical dimension - MUST be applied **For cooktop cutout dimensions refer to model-specific product installation instructions on the web Electric Cooktop Installation Over 30" Single Electric Wall Oven Specifications Single Wall Ovens are approved to be used beneath Electrolux ICON™ electric cooktop models E36IC75FSS, E30IC75FSS, E36EC70FSS and E30EC70FSS (electric cooktop models NOT approved for use in this installation are E36EC75ESS, E30EC65ESS and E36EC65ESS. For detailed Electric Cooktop installation specifications, refer to product-specific section, pages 18-35. • Side filler panels necessary to isolate oven from adjoining cabinets. Panel height may need to be modified to accommodate the depth of approved electric cooktop models. • To route armoured cable to junction box, cut minimum 4" x 4" opening in right cabinet side panel. • Allow 4-1/2" maximum height from oven base to floor, if cooktop is installed directly over wall oven. 30" Single Electric Wall Oven Under-Counter Installation Specifications • Product Weights - (E30EW75EPS) 177 Lbs. / (E30EW75ESS) 168 Lbs. • Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line. • Connected Load (kW Rating) - 240 / 208 Volts = 4.0 / 3.0 kW • Amps @ 240 / 208 Volts = 16.6 / 14.4 Amps • Always consult local and /or national electric codes. • Minimum 23-1/4" clearance for oven door depth when open. • Minimum 24" deep, cutout dimension is critical for proper installation. If oven's face profile does not fit flush against cabinet, or if noise is heard from oven's convection system, verify dimension. • Full oven base of solid plywood or similar material required, capable of supporting 200 Lbs. Install over two runners and flush with toe plate. • Base must be level and cabinet front must be square. • Side filler panels necessary to isolate oven from adjoining cabinets. • Allow 5" maximum height from oven base to floor, if NO cooktop is installed directly over wall oven. Note: Refer to Product Installation Guides for detailed instructions on the web at electroluxusa.com.