Electrolux E30EW75ESS Use and Care Manual - Page 8

8 Getting Started BEFORE SETTING OVEN CONTROLS Oven Vent Location The oven is vented under upper control panel. When the oven is on, warm air is released through the vent. This venting is necessary for proper air circulation in the oven and good baking results. Oven Vent Warm Air Installing Oven Rack Supports ALWAYS INSTALL OVEN RACK SUPPORT BEFORE TURNING ON THE OVEN (WHEN THE OVEN IS COOL). To install oven rack support, insert the support tabs in the holes located on the oven inside side as shown below. To remove the oven rack support for a self-clean cycle, pull up the support to disengage the tabs from the oven. If the rack supports are not removed, the self-clean cycle won't start. Always remove the left side support first. Removing and Replacing Oven Racks ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven mitts when using the oven. To remove an oven rack, pull the rack forward. Lift up the rack off the oven rack slider. To replace an oven rack, place the rack on the slider and fit the sliders pin into the pinhole located at the 2 front corner of the rack. Installed on sliders Rack positions 7 6 5 4 3 2 1 To remove from sliders Pull oven rack forward and lift it up of the oven rack slider. To place on sliders Arranging Oven Racks ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). To bake on a single rack, place the rack in position 3. To bake on 2 racks, place the racks in position 2 and 7. To bake on 3 racks, place the racks in position 1, 3 and 7. RECOMMENDED RACK POSITIONS FOR BROILING, BAKING & ROASTING Food Rack Position Broiling meats, chicken or fish 6 or 7 Cookies, cakes, pies & muffins 5 or 6 Frozen pies, angel food cake, yeast, bread, 2 casseroles, small cuts of meat or poultry Turkey, roast or ham 1 Note: Always use caution when removing food.