Electrolux E32AR75FPS Owners Guide - Page 8

8 Installation TO LEVEL REFRIGERATOR: After discarding crating screws and wood base, use a carpenter's level to level the refrigerator from front to back. Adjust the plastic leveling feet in front, 1/2 bubble higher, so that the door closes easily when left halfway open. LEVELING INSTRUCTIONS FOR ALL REFRIGERATOR / FREEZER PAIR: • Remove two leg levelers provided in literature bag. While unit is lying on its back for wood skid removal, install both leg levelers in rear of unit. • Level door of first unit using all four levelers and slide unit into place. Recheck for levelness and adjust if necessary. • Measure distance from floor to bottom of door on first unit. Adjust and level second unit so door height matches. • Leg Level Adjustments: • One full turn of all four leg levelers will raise door 5/32". • One full turn of both front leg levelers will raise door 3/16" and tilt top of door back 7/16". • One full turn of both rear leg levelers will lower door 1/32" and tilt top of door forward 7/16". • One full turn of both side leg levelers will raise door 3/16" and tilt top of door 3/8". • Slide second unit into place leaving a minimum gap of 3/16" between units for door swing clearance. • This last step may require at least one extraction of the second unit to properly align units in a "built-in" application. ! CAUTION To allow door to close and seal properly, do not let food packages extend past the front of the shelves.