Electrolux E36DF76EPS Installation Instructions - Page 24
Operation - troubleshooting
View all Electrolux E36DF76EPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
24 Operation VERIFYING THE OPERATION NOTE REFER TO THE USE AND CARE MANUAL FOR DETAILED INSTRUCTIONS. Before beginning the test procedure, ensure that all cooktop control valves are in the "OFF" position, and all burner rings, burner caps, and grates are properly positioned on the top frame. Turn on the gas supply at the shut-off valve. Turn on the power supply to the range. Select a temperature of 350°F by rotating the temperature control knob to "350" and selecting "BAKE" with the oven selector knob. Rotate each knob to the "Off" position to stop the heating process. For model E48DF76EPS, repeat this test procedure with the companion oven. Test each top burner separately by pressing and turning one control knob at a time counterclockwise to the "HIGH" position. All ignitors will spark continuously, but only the burner with gas flowing to it will ignite. (It will take approximately 4 seconds for ignition to occur, at which time the ignitors will stop sparking. If ignition does not occur within 4 seconds, turn off the knob, wait for at least 2 minutes to allow any gas to dissipate, then repeat this ignition test.) The control knob can then be rotated counterclockwise from "HIGH" to "LOW" to adjust the flame height progressively. Repeat the ignition test for all burners. When installed properly, the flame will be steady and quiet. It will also have a sharp, blue inner cone that will vary in length proportional to the burner size. WARNING • The range and shut-off valve must be disconnected from the gas supply piping during any pressure testing exceeding 1/2 psi (3.5kPa). • The range must be isolated from the gas supply piping by closing the shut-off valve during any pressure testing at or below 1/2 psi (3.5 kPa). NOTES If either the oven or cooktop does not operate properly, follow these troubleshooting steps: • Verify that power and gas are supplied to the range. • Check the electrical connections and gas supply to ensure that the installation has been completed correctly. • If the appliance still does not work, contact an authorized service company. Do not attempt to repair the appliance yourself. Electrolux is not responsible for service required to correct a faulty installation.