Electrolux ECVI4262AS Complete Owners Guide English - Page 9

Examples of possible ducting or air recirculation Fig. Recirculation kit shown NOTE 1.The center of the template must match the center of the cooktop and the edges must be parallel to the sides of the cooktop. 2.Have a suitable ladder ready so that you can easily reach up to the ceiling. Step 2 Unscrew 16 screws between the two sections of the structure. Adjust extension of the hood support structure (dimenssion A), as the final height of the hood depends on this ,and remember that with installation completed to the hood must be at least 30" above the cooktop. Fig. IMPORTANT This range hood is very heavy. Adequate structure and support must be provided in all types of installations. Step 1 Make sure that no cables or pipes will become damaged (e.g. electric, gas, water; test the areas in question with a cable detector). Using the template, mark and drill 4 holes into the ceiling. Measure as displayed in diagram (fig. 5 ). The holes must be drilled into a wood structure capable to support 150lbs load. 1 With 8'/12'/14' extension chimney kit - not supplied. Please call Electrolux at 1-800-944-9044 (USA) or 1-800-2658352 (Canada) to order this kit. 2 " Dimension A" represents the height from the top of upper bracket to the top of lower bracket (fig. 6 ). Fig. Step 3 71/16" 101/16" Fix the two sections of the structure using 16 screws. 71/16" NOTE 101/16" It is recommended to fix the supplied 4 supporting brackets (10,11) with sponge strips(12,13)onto the lower brackets to make sure two flue covers fit closely(fig. 7 ). 9 ENGLISH