Electrolux EDSH4944AS Complete Owners Guide English - Page 5

Features

Page 5 highlights

Features 5 Upper Spray Arm Cutlery Rack Tub Gasket Cup Shelves Soft Grip Rack Middle Spray Arm Stemware Holder Bottom Rack Lower Spray Arm Detergent Dispenser Rinse Aid Dispenser Adjustable Rack Mechanism Upper Rack Flex Wash Interior Light Silverware Basket Filters Serial Label (located on right side of door) How your dishwasher cleans Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms against soiled surfaces. First, the dishwasher drains for a few seconds to remove soils dropped while loading, then fills with water covering the filter area. Water is then pumped through the spray arms. Soil particles go through and across the filter and down the drain as the water is pumped out. This series of steps are repeated as needed. The number of water fills varies with the cycle being used. NOTE Racks and Features in your dishwasher model may vary in appearance from illustrations in this manual. Getting started To run your dishwasher, follow these basic steps: 1. Load Dishwasher (see loading instructions). 2. Add detergent to the dispenser (see Filling the detergent dispenser). 3. Add Rinse Aid to the dispenser, if needed (see Using the rinse aid dispenser). 4. Run hot water faucet nearest dishwasher until water is hot. Turn water off. 5. Select desired cycles (see Cycle selection). 6. Select desired options (see Option selection). 7. To start, press START pad and close door immediately.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

5
Features
Upper Spray Arm
Adjustable
Rack
Mechanism
Flex Wash
Silverware
Basket
Filters
Serial Label
(located on
right side
of door)
Tub
Gasket
Cup
Shelves
Soft Grip
Rack
Middle
Spray Arm
Bottom
Rack
Stemware
Holder
Lower
Spray Arm
Detergent
Dispenser
Rinse Aid
Dispenser
Cutlery Rack
Upper Rack
Interior Light
How your dishwasher
cleans
Your dishwasher cleans by spraying
a mixture of hot water and detergent
through the spray arms against soiled
surfaces. First, the dishwasher drains for
a few seconds to remove soils dropped
while loading, then fills with water covering
the filter area. Water is then pumped
through the spray arms. Soil particles go
through and across the filter and down
the drain as the water is pumped out. This
series of steps are repeated as needed.
The number of water fills varies with the
cycle being used.
Getting started
To run your dishwasher, follow these basic
steps:
1. Load Dishwasher (see loading
instructions).
2. Add detergent to the dispenser (see
Filling the detergent dispenser).
3. Add Rinse Aid to the dispenser,
if needed (see Using the rinse aid
dispenser).
4. Run hot water faucet nearest
dishwasher until water is hot. Turn
water off.
5. Select desired cycles (see Cycle
selection).
6. Select desired options (see Option
selection).
7. To start, press
START
pad and close
door immediately.
NOTE
Racks and Features in your dishwasher
model may vary in appearance from
illustrations in this manual.