Electrolux EI28BS56IW Use and Care Guide - Page 20

Automatic ice, Water Maker/Dispenser

Page 20 highlights

Automatic ice Water Maker/Dispenser ice maker/dispenser tips ,, If your refrigerator is not connected to a water supply or the water supply is turned off, turn off the ice maker by holding the OrdOff soft-touch icon and the water shut-off valve for three (3) seconds. ,, The following sounds are normal when the ice maker is operating: Motor running Ice dropping into ice bin Water valve opening or closing Running water ,, When dispensing ice, you will hear a snapping or clicking sound when the ice chute opens and closes. If you need a large quantity of ice at one time, it is best to get cubes directly from the ice bin. Turning off the ice maker will result in the ice melting in the bin. Ice cubes stored too long may develop an odd flavor. Empty the ice bin as explained below. CAUTION if the water supply to your refrigerator is softened, be sure the softener is properly maintained. Chemicals from a water softener can damage the ice maker. Cleaning the ice maker Clean the ice maker and ice bin at regular intervals, especially prior to vacation or moving. 1 Turn off the ice maker. 2 Remove the ice bin by pulling straight out. 3 Empty and carefully clean the ice bin with mild detergent. Do not use harsh or abrasive cleaners. Rinse with clear water. Removing lee Bin 4 Allow the ice bin to dry completely before replacing in the freezer. 5 Replace the ice bin. Turn the ice maker on. Remove and empty the ice bin if: o An extended power failure (one hour or longer) causes ice cubes in the ice bin to melt and freeze together, jamming the dispenser mechanism. • You do not use the ice dispenser frequently. Ice cubes wilt freeze together in the bin, jamming the dispenser mechanism. Remove the ice bin and shake to loosen the cubes or clean as explained above. CAUTION NEVER use an ice pick or similar sharp instrument to break up the ice. This could damage the ice bin and dispenser mechanism. To loosen stuck ice, use warm water. Before replacing the ice bin, make sure it is completely dry. IMPORTANT When removing or replacing the ice bin, DO NOT rotate the auger in the ice bin. If the auger is accidentally rotated, you must realign the auger by turning it in 90 degree turns (see below) until the ice bin fits into place with the drive mechanism. If the auger is not properly aligned when replacing the ice bin, the refrigerator will produce no ice. The fresh food door also may not close properly causing warm air to leak into the fresh food compartment. Auger Adjusting lee Bin Auger

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38

Automatic ice
Water Maker/Dispenser
ice maker/dispenser
tips
,,
If your refrigerator
is not connected to a water
o
supply or the water supply is turned off, turn off
the ice maker by holding the OrdOff
soft-touch
icon and the water shut-off valve for three (3)
seconds.
,,
The following sounds are normal when the ice
maker is operating:
Motor running
Ice dropping into ice bin
Water valve opening or closing
Running water
,,
When dispensing
ice, you will hear a snapping
or clicking
sound when the ice chute opens and
closes.
If you need a large quantity of ice at one time, it is
best to get cubes directly from the ice bin.
Turning off the ice maker will result in the ice
melting in the bin.
Ice cubes stored too long may develop an odd
flavor. Empty the ice bin as explained
below.
CAUTION
if
the
water
supply
to
your refrigerator
is softened,
be sure
the softener
is properly maintained.
Chemicals
from
a
water softener
can
damage
the
ice maker.
Cleaning
the
ice maker
Clean the ice maker and ice bin at regular intervals,
especially
prior to vacation or moving.
1
Turn off the ice
maker.
2
Remove the ice bin
by pulling straight
out.
3
Empty and carefully
clean the ice bin
with mild detergent.
Do not use harsh or
abrasive cleaners.
Rinse with clear
Removing lee Bin
water.
4
Allow the ice bin to dry completely
before
replacing in the freezer.
5
Replace the ice bin. Turn the ice maker on.
Remove and empty the ice bin if:
An extended power failure (one hour or longer)
causes ice cubes in the ice bin to melt and freeze
together, jamming
the dispenser
mechanism.
You do not use the ice dispenser frequently. Ice
cubes wilt freeze together
in the bin, jamming the
dispenser
mechanism.
Remove the ice bin and shake to loosen the cubes or
clean as explained above.
CAUTION
NEVER use an ice pick or similar sharp
instrument
to
break
up
the
ice. This
could
damage
the
ice
bin and
dispenser
mechanism.
To
loosen
stuck ice, use warm water.
Before
replacing the ice
bin,
make sure it is completely
dry.
IMPORTANT
When removing or replacing the ice bin, DO NOT
rotate the auger in the ice bin. If the auger is
accidentally
rotated, you must realign the auger by
turning it in 90 degree turns (see below) until the ice
bin fits into place with the drive mechanism. If the
auger is
not properly aligned when replacing the ice
bin, the refrigerator
will produce no ice. The fresh food
door also may not close properly causing warm air to
leak into the fresh food compartment.
Auger
Adjusting
lee Bin Auger