Electrolux EI28BS56IW Use and Care Guide - Page 9

installation 9 Lift the door while adjusting the washer. To raise the door, rotate washer clockwise (when viewed from the bottom). To lower door, rotate washer counter-clockwise (when viewed from the bottom). To adjust the flipper mullion: 1 Loosen the set screw located on the flipper mullion hinge. m _-Flipper Mullion t Raising/Lowering Door Re-tighten the set screw, ensuring it is between the spokes of the set washer. Set screw will not be tight, just insert until it is flush with the hinge. Re-tighten Set Screw Flipper _ Mullion- Hinge Set Screw Adjusting Flipper Mullion Screw 2 Adjust flipper mullion height. For proper connection with the flipper mullion guide, there should be a separation about the thickness of a coin (0.060 inches, or 1.5 mm) between the guide and flipper mullion. Flipper Mullion Set Screw NOTE If after adjusting doors higher the door makes a popping/clicking sound, remove set screw and replace with a longer one. Adjusting Flipper Mullion Height 3 Re-tighten set screw.