Electrolux EI30SM55JW Use and Care Manual - Page 31
Caution
View all Electrolux EI30SM55JW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
CLEANING AND CARE 31 Disconnect the power cord before cleaning or leave the door open to deactivate the oven during cleaning. CHARCOAL FILTERS Charcoal Filters, which are attached with Hood Louver, are used for nonvented, recirculated installation. The filter should be changed every 6 to 12 months depending on use. 1. Disconnect power to the microwave oven at the circuit breaker panel or by unplugging. 2. Remove three Houver Louver Screws. 3. Push the upper tabs and pull the louver away from the unit. 4. Remove the charcoal filters from hood louver and replace new charcoal filters by piercing tabs into the holes in charcoal filters. 5. Carefully push the louver back into place and replace the screws removed at step 2. MICROWAVE OVEN LIGHT Remove the louver per instructions 1-3 above, if used. 1. To replace krypton light bulb, first disconnect power to the microwave oven at the circuit breaker panel or by unplugging. 2. Open oven light cover by carefully pulling up on the front edge. See figure 1. 3. Remove light bulb and replace 40 watts krypton light bulb. DO NOT USE BULB LARGER THAN 40 WATTS. 4. Close the Oven Light Cover by carefully pushing into place. Push the louver back into place (engaging both the bottom and top tabs) and replace three Houver Louver Screws. Oven Light Cover Hood Louver Screws VENT HOOD LIGHT BULBS 1. To replace krypton light bulb, first disconnect power to the microwave oven at the circuit breaker panel or by unplugging. 2. To open Light Cover, remove the screw on the light cover. (See Figure 3.) 3. Replace the 40 watts krypton light bulb with new one. DO NOT USE A BULB LARGER THAN 40 WATTS. 4. Close the Light Cover and secure with screw removed at step 2. Figure 1 Hood Louver BOTTOM VIEW Light Bulb (Front of microwave oven) Inside of Hood Louver Charcoal Filters Upper Tab Figure 3 (Rear of microwave oven) Light Cover Screw Tabs Figure 2 CAUTION Light Cover may become very hot. Do not touch glass when light is on. E