Electrolux EI48HI55KS Complete Owner's Guide (Español) - Page 11
Electrolux EI48HI55KS Manual
View all Electrolux EI48HI55KS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Blower Motor Systems Installation 11 previously removed. If it is removed, reattach the motor electrical plug to the connector on the blower motor assembly. joints. Use furnace duct tape to seal all joints tightly. A B Complete Preparation 1. Determine and make all necessary cuts for the vent system. IMPORTANT: When cutting or drilling into the ceiling or wall, do not damage electrical wiring or other hidden utilities. 2. Determine the location where the ½" (1.3 cm) wiring conduit will be routed through the ceiling or wall between the remote blower and the hood insert. 3. Drill a 1¹⁄4" (3.2 cm) hole at this location. 4. Locate the electrical terminal boxes in the remote blower housing and hood insert (see "Complete Preparation" in the "Prepare Location" section). Remove the terminal box covers and set the covers and screws aside. B A C E D F G A. Vent System B. Remote Blower Motor C. Ceiling D. Roof rafters / Plywood E. Remote Blower Wiring Conduit F. Hood Insert Wiring Conduit G. Hood Insert Make Electrical Connections for Remote Blower Motor System Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. Electrical Connection Inside Remote Blower System 1. Disconnect power. 2. Connect the wires from the wiring conduit to the wires from the motor electrical plug cable inside the remote blower housing terminal box. C E F H A I D A. Electrical terminal box B. Electrical knockout 5 6. 7. 8. 9. Remove the electrical knockout from the remote blower housing and hood insert (see "Preparation" in the "Prepare Location" section) to prepare for the installation of the UL listed or CSA approved ½" (1.3 cm) wiring conduit and conduit connector. NOTE: Strain relief conduit are supplied with remote blower hardware. With the hood insert mounted (see the "Install Hood Insert" section), run the ½" (1.3 cm) wiring conduit between the remote blower motor housing and the hood insert. Pull enough ½" (1.3 cm) wiring conduit to allow for easy connection to the terminal boxes in the remote blower housing and hood insert. Run the six 18 AWG wires through the 1⁄2" (1.3 cm) wiring conduit and conduit connectors and into the terminal boxes on the remote blower housing and hood insert. Leave enough wire length in each terminal box to make the wiring connections. Install the conduit connectors and conduit to the remote blower housing and hood insert electrical terminal boxes. NOTE: Strain relief conduit are supplied with remote blower hardware. Connect the vent system to the hood insert and remote blower motor system. Use clamps at all B G A.UL listed or CSA approved 1 ⁄2" (1.3 cm) wiring conduit B.UL listed wire connectors C.Black wires D.White wires E. Red wires F. Blue wires G. Gray wires H. Green (or yellow/green) and green/yellow wires I.Motor electrical plug cable