Electrolux EIGD55H Installation Instructions - Page 13

Installation instructions i 4-wire receptacle I I (NEMA type 14-30R) ELECTRICAL SHOCK HAZARD Failure to disconnect power source before servicing could result in personal injury or even death. 1. Turn off power supply to outlet. 2. Remove the screw securing the terminal block access cover in the lower corner on the back of the dryer. 3. Install a UL-approved strain relief according to the power cord/strain relief manufacturer's instructions in the power cord entry hole below the access panel. At this time, the strain relief should be loosely in place. 4. Thread an UNPLUGGED, UL-approved, 30 amp. power cord, NEMA 14-30 type ST or SRDT, through the strain relief. 5. Disconnect the internal (BLACK) dryer harness ground wire from the (GREEN) ground screw next to the terminal block. 6. Attach the ground (GREEN) power cord wire to the cabinet with the ground (GREEN) screw. Tighten the screw securely. 7. Move the internal dryer harness ground (BLACK) wire to the terminal block and attach it along with the neutral (WHITE) power cord wire conductor to the center, SILVER colored terminal on the terminal block. Tighten the screw securely. 8. Attach the RED and BLACK power cord conductors to the outer, BRASS colored terminals on the terminal block. Tighten both screws securely. ELECTRICAL SHOCK HAZARD Do not make a sharp bend or crimp w_ringi conductor at connections. 9. Follow manufacturer's guidelines for firmly securing the strain relief and power cord. 10. Reinstall the terminal block cover. '_!_ } N3MOAIA_P30 --Neutral WHITE w_re) -____/(GRGEELNnd,re) _, _ _._--- Access cover " _----_--'_ . _---Terminal , J___ "_ _ block '_ _,' _, , "_ _,'-, I_1 ,i'-", g-_ ' ,I, o ,,',!" (BRASS terminal) "_ Internal ground (GREEN screw) UL-approved strain Inrestaelfl here Terminal screw _," recovery slot If a terminal screw falls during cord installation, it can be retrieved in the terminal screw recovery slot below the access panel. Move internal ground (BLACK) wire to neutral (SILVER) terminal for 4-w_re system, "h ( GREEN ground screw Neutral terminal WHITE neutral wire GREEN ground _ re\(,,,,",,,,, \,,,, BLACK or RED power wire / /"/ BLACK / /,," or RED //_/ power wire ///