Electrolux ELFW4222AW Complete Owners Guide English - Page 30
Alarm Code, Possible Causes, Solution
View all Electrolux ELFW4222AW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
30 Solutions to Common Problems In some instances, an alarm code will be shown on the display and a tone will be emitted by the unit. The alarm code will be flashed in alternating fashion between the letters "AL" and a specific two-character code. Before calling for Service, refer to the table below for possible solutions to the alarm codes listed. ALARM CODE POSSIBLE CAUSES SOLUTION AL 10 The appliance is not filling with water properly. • Ensure the water tap is fully open. • Ensure the water pressure is not too low. For this information, contact your local water authority. AL 20 The appliance is not draining water properly. • Ensure the water tap is not clogged. • Ensure the inlet hose has no kinks, damages or bends. • Ensure the inlet hose is properly connected. • Ensure the filter of the inlet hose is not clogged. • Reset the appliance by either turning the knob to the reset position (12 o'clock position) or powering off the unit off and back on. • Ensure the drain hose has no kinks or bends. • Ensure the drain hose is not clogged. • Ensure the drain hose is connected properly. • Ensure the house drain pipes are not clogged. Contact a plumber if necessary. • Reset the appliance by either turning the knob to the reset position (12 o'clock position) or powering off the unit off and back on. AL 40 AL 91 AL F0 AL H0 • If water was left in the drum and needs to be drained, turn the knob to the "rinse & spin" cycle, deselect the "fresh rinse" option and change the spin option to "NO SPIN", then press start. The door is open or • Close the door completely. not shut completely • Reset the appliance by either turning the knob to when the start button the reset position (12 o'clock position) or powering is pressed. off the unit off and back on. There is a • Reset the appliance by either turning the knob to disrupt in internal communication the reset position (12 o'clock position) or powering off the unit off and back on. between electronic elements of the unit. The anti-flood device • Close the water taps to the washer inlet hoses. has been activated. • Unplug the appliance. • Call for Service. There is an issue with • Wait until the power supply is stable. the power supply. • Ensure the power cord is still in proper operating condition. • Ensure the wall outlet is in proper operating condition. • Reset the appliance by either turning the knob to the reset position (12 o'clock position) or powering off the unit off and back on. If any other Alarm Codes other than the ones listed above are shown on the display, first try to reset the appliance by either turning the knob to the reset position (12 o'clock position) or powering off the unit off and back on. If any Alarm Code reappears after resetting the appliance, contact Service for further assistance.