Electrolux ELFW4222AW Complete Owners Guide English - Page 8

8 Operating Instructions STEPS TIPS IMPORTANT • Press the power • See Cycle Selection, Cycle Settings, and Cycle Follow fabric care label Options for detailed descriptions of cycle controls. instructions on items to button and select the appropriate cycle and settings for each load. Add cycle options as desired. • See Settings Chart to determine which settings are available for each cycle. • To provide the best care, not every setting or option is available with every cycle. If attempting to select an unavailable setting or option for any given cycle, a beep will be heard and the corresponding setting/option LED will not light. See Settings Chart for information on available options for each cycle by model. be washed. 6. Close the • Close the door and press start/pause. The washer door washer will not operate with the door open. If DO NOT force door open. As a safety and start start/pause is pressed while the washer door is measure, the door the washing open, a beep will be heard and "AL" and "40" will will automatically cycle. be displayed, signaling that the cycle cannot be lock during the entire started until the door is closed. Close the washer wash cycle and the door, turn the knob to the reset position (12 o'clock LED above the start/ position), then re-select cycle, settings, and options pause button will be and press start/pause to begin cycle. • To add a forgotten item to the wash drum, press the start/pause button. Once the wash drum continuously lit. Pause or cancel the cycle to unlock the door. has stopped moving, the door will unlock, and the LED above the start/pause button will blink. The estimated remaining cycle time will be displayed. Add the item, close the door and press start/pause to resume the cycle. If the cycle is interrupted during spin, the door lock will not release until the drum has stopped spinning. • To change the cycle and/or settings once the cycle has begun (after the start button has been pressed), either rotate the knob to the reset position (12 o'clock position) OR press the power button to turn off the unit and cancel the cycle. Press the power button again to turn on the unit and select If the water level is above the bottom of the door opening/flexible door gasket, the lock will not release. the new cycle and/or settings, and press start to begin. Changing a cycle selection without canceling the current cycle WILL NOT change the cycle. Cycle settings and options CANNOT be changed unless the current cycle is cancelled. Note: there is an exception if the start button has been pressed to begin a cycle and the delay start function is activated and counting down. In this case, during the delay start countdown, the cycle can be paused and cycle settings and/or options can be changed. Then press start again to resume the delay start countdown. 7. Remove items from washer when cycle has ended. • To cancel a cycle, turn the knob to the reset position OR press the power button to turn off the unit. • A signal will sound at the end of the cycle if the mute sound option is not activated. • Remove items when the cycle ends and place in dryer, line dry or dry flat as directed on the fabric care label. Excess wrinkling, color transfer or odors may develop in items left in the washer after the cycle has ended.