Emerson CF788 Owner Manual - Page 12
Wall Control Installation, Wall Control Procedures
View all Emerson CF788 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Wall Control Procedures General Your Emerson Ceiling Fan/Light Control consists of wall mounted transmitter and a receiver which is mounted under the fan ceiling cover. The remote control is designed to separately control your ceiling fan speed and light intensity. Code switches in the transmitter and receiver may be set in 32 different positions. If your fan and light go on and off without using your control, you may be getting interference from other remote units such as garage door openers, car alarms or security systems. To remedy this situations, simply change the combination code in your transmitter and receiver. Preset Memory Feature Your Emerson receiver is equipped with a preset memory feature. If the AC supply to the receiver is powered through a wall switch, when the switch is turned OFF, the control will remember the light intensity and fan speed. When the switch is turned back ON the light and fan will resume operation as they were prior to the switch being turned OFF. Setting Operating Frequency of Wall Control Your wall control has code switches which must be set in one of 32 possible code combinations (Figure 15). The five levers (numbered 1, 2, 3, 4, and 5) on the switches are factory-set in the ON (up) position. Change the switch settings as follows: 1. Slide the five switch levers in the wall control to your choice of ON (up) or down positions. Use a ball-point pen or small screwdriver and slide the levers firmly up or down. 2. When power is restored after installation of the wall control, push and hold the fan OFF button ( ) for 3 to 5 seconds to set the code in the receiver. 3. The sixth switch marked ON and I is for dimming control of lights: Set switch to ON to allow for dimming of the lights. Set switch to I for no dimming of the lights such as for fluorescent bulbs. WALL CONTROL Figure 15 WALL CONTROL CODE SWITCHES ON 1 2 3 45 I CODE SWITCHES Wall Control Installation (continued) SINGLE-POLE INSTALLATION ! WARNING Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock. CAUTION: To reduce the risk of electrical shock, disconnect the electrical supply circuit before installing the fan, light kit or receiver. HOT BLK HI MED LIGHT LOW FAN OFF EMERSON® OFF ON FAN/LIGHT WALL CONTROL BLACK LOAD BLACK NEUTRAL RECEIVER LOCATED ON TOP OF THE CEILING FAN Figure 16 GROUND 12 ETL Model No.: CF788