Emerson CF788 Owner Manual - Page 14

Wall Control Installation (continued) 3-WAY WIRING DIAGRAM: NEW CONSTRUCTION STANDARD WIRING FOR EXISTING 3-WAY CONTROLS ! WARNING Check to see that all connections are tight and that no bare wires are visible at the wire connectors. HOT BLK EXISTING WALL CONTROL BLACK 6. Screw wall control into wall box using the supplied screws. Leave wall control in "OFF" mode until fan installation is completed. 7. The wall control is supplied with a white, ivory, and almond color switch covers. Choose the finish that best suits your needs and snap the cover onto the wall control (Figure 18). 8. Next, install the other wall control into the wall box containing the load wire. Connect the black wire of the wall control to the traveler wire(s) already connected to the black wire (in the other wall box). Secure with wire connectors supplied. 9. Connect one black wire of the wall control to the "load" (black) wire and secure with wire connector supplied. TRAVELER WIRES LOAD 3-WAY WIRING DIAGRAM: RETROFIT HOT BLK HI MED LIGHT LOW FAN OFF EMERSON® OFF ON FAN/LIGHT WALL CONTROL Figure 19 BLK BLK HI MED LIGHT LOW FAN OFF EMERSON® OFF ON BLK BLACK TRAVELER WIRES LOAD HOT BLACK HI MED LIGHT LOW FAN OFF EMERSON® OFF ON SW605 FAN/LIGHT WALL CONTROL HI MED LIGHT LOW FAN OFF EMERSON® OFF ON NEUTRAL TRAVELER WIRE RECEIVER LOCATED ON TOP OF THE CEILING FAN BLK BLK LOAD BLACK GROUND Figure 18 High Speed Conditioning of Fan Control IMPORTANT: The following steps must be completed immediately following the frequency programming of the ceiling fan. 1. Press the ( ) speed button until all 6 LED indicators are lit. Let the fan operate on high speed for 2 minutes without interruption. 2. After 2 minutes, press the reverse ( ) button and allow the fan to operate uninterupted for 2 minutes at high speed. 3. High speed conditioning is now complete. 14 ETL Model No.: CF788