Emerson CF788 Owner Manual - Page 5

THESE FAN MODELS ARE SUITABLE FOR DAMP LOCATIONS SUCH AS COVERED PORCHES, COVERED PATIOS, AND COVERED DECKS... ANYWHERE THERE IS A ROOF OVERHEAD. This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Tools Needed for Assembly One Phillips head screwdriver One wire stripper One stepladder MATERIALS Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size: Installed Wire Length Up to 50 ft. 50-100 ft. Wire Size A.W.G. 14 12 ! WARNING Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 10). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician. Unpacking Instructions ! WARNING Do not install or use fan if any part is damaged or missing. Call Toll-Free: 1-800-654-3545 ! WARNING This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage. 1. Check to see that you have received the following parts: NOTE: If you are uncertain of part description, refer to exploded view illustration. a. Fan motor assembly b. One switch housing c. One ceiling cover d. Five blade flanges e. One hanger ball/4.5" downrod assembly f. One hanger bracket g. One motor coupling cover h. One transmitter control with switch covers i. One receiver control j. One loose parts bag containing: 1. Twenty-one #10-24 x 12mm washer head blade screws 2. Twenty-one 16mm flat washers OD 3. One #8-32 X 12mm flat head screw 4. One 1/4-20 x 14mm pan head screw 5. One 6mm lockwasher 6. Three wire connectors 7. Two #8-32 x 1-1/4" threaded studs 8. Two #8-32 knurled knobs 9. Two #8 external tooth lockwashers 10. One clevis pin 11. One hairpin clip 12. One balance kit NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding. 2. Remove the fan assembly from the protective plastic bag. Place the fan assembly into the upper foam pad with the bottom of the motor facing up. The upper foam pad serves as a holder for the fan during the first stages of assembly. J. LOOSE PARTS BAG D. BLADE FLANGES I. RECEIVER CONTROL A. FAN MOTOR ASSEMBLY E. HANGER BALL/ DOWNROD ASSEMBLY C. CEILING COVER G. MOTOR COUPLING COVER B. SWITCH HOUSING F. HANGER BRACKET H. WALL CONTROL 5 ETL Model No.: CF788