Epic Fitness A30e Elliptical English Manual - Page 14

14. Have a second person hold the Console (7) near the Console Bracket (62). Connect the Ground Wire (119) to the matching wire on the Console (7). Then, insert all of the wires on the Console downward through the indicated hole in the Console Bracket (62). Tip: Avoid pinching the wires. Attach the Console (7) to the Console Bracket (62) with four M4 x 16mm Screws (104). Untie and discard the wire tie (not shown) on the Main Wire Harness (110). See the inset drawing. Connect the Main Wire Harness (110) and the two indicated wires to the matching wires on the Console (7). Make sure to connect the wire that has a tag to the wire on the Console that has a tag. 14 7 Hole Avoid pinching the wires 119 62 104 104 7 110 Wires 15. Note: For clarity, the Console and the wiring are not shown in this step. 15 Tip: It may be necessary to turn the Console Knob (52) and adjust the angle of the Console Bracket (62). Attach the Upper Handlebar Cover (56) to the Right and Left Handlebars (83, 87) and to the Console Bracket (62) with three M4 x 16mm Screws (104); start all three Screws, and then tighten them. Make sure that the wiring (not shown) is inside the Upper Handlebar Cover (56). Then, press the Lower Handlebar Cover (60) onto the Upper Handlebar Cover (56). 56 62 87 52 60 104 104 83 14