Epic Fitness A30e Elliptical English Manual - Page 8

Tip: Avoid pinching the Sensor Wire

Get Epic Fitness A30e Elliptical PDF manuals and user guides View all Epic Fitness A30e Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

3. Set the Rear Stabilizer (5) on the floor behind the Frame (1). Locate the wire tie in the Rear 3 Stabilizer. See the inset drawing. Tie the end of the wire tie to the Sensor Wire Harness (155). Pull the other end of the wire tie until the Sensor Wire Harness (155) is routed through the Rear Stabilizer (5). Wire 5 Tie 155 1 Wire 155 Tie Wire Tie 4. Tip: Avoid pinching the Sensor Wire Harness (155). 4 Set a sturdy piece of packing material under the rear of the Frame (1). Have a second person hold the Frame to prevent it from tipping while you complete this step. Avoid pinching the Sensor Wire Harness (155) Insert the Rear Stabilizer (5) into the Frame (1). Attach the Rear Stabilizer with four M8 x 16mm Screws (72); start all four Screws, and then tighten them. Remove the packing material. 72 155 5 72 1 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
8
3
3.
Set the Rear Stabilizer (5) on the floor behind
the Frame (1). Locate the wire tie in the Rear
Stabilizer.
See the inset drawing.
Tie the end of the wire
tie to the Sensor Wire Harness (155).
Pull the other end of the wire tie until the Sensor
Wire Harness (155) is routed through the Rear
Stabilizer (5).
1
5
155
Wire
Tie
Wire
Tie
155
Wire Tie
4
4.
Tip: Avoid pinching the Sensor Wire
Harness (155).
Set a sturdy piece of packing material under the
rear of the Frame (1).
Have a second person
hold the Frame to prevent it from tipping
while you complete this step.
Insert the Rear Stabilizer (5) into the Frame (1).
Attach the Rear Stabilizer with four M8 x 16mm
Screws (72);
start all four Screws, and then
tighten them.
Remove the packing material.
72
155
72
1
5
Avoid pinching
the Sensor Wire
Harness (155)