Epson 1810p Product Information Guide - Page 14

PowerLite 1810p/1815p ❏ IP address: Enter the IP address you want to assign to the projector. It must be formatted like other addresses on the network. The last octet should be unique. ❏ Subnet mask: For example: 255.255.255.000, but this depends on how your network is set up. ❏ Gateway address: Enter the IP address that was assigned to the access point or AirPort base station when it was set up. 8. When you're done making these settings, select Return, Setup complete, and then Yes to confirm that you want to save the changes. Press Menu to exit the menu system. Now you're ready to set up your computer for wireless projecting. Go to "Configuring the Network Settings for Windows" in the next section, or go to "Configuring the Network Settings for Macintosh" on page 16. Note: For specific details about your network, please consult your network administrator. If you don't know your gateway or access point address, see page 16. If you're using AirPort, start the AirPort Admin utility, select your base station and click Configure. Then click the Network tab to see your base station's IP address. Configuring the Network Settings for Windows Before connecting to the projector, you need to make sure the settings for your computer's wireless card or adapter match the settings you entered for the projector. 1. Access your wireless network Properties window. For example, in Windows XP you would click Start > Control Panel > Network and Internet Connections. Then click the Network Connections icon. You see a screen similar to this: 2. Right-click the Wireless Network Connection icon and select Properties. You see a screen similar to this: Click here 3. Click the Configure button. 4. Click the Advanced tab. You see a screen like this: Right-click and select Properties 14 - PowerLite 1810p/1815p 5. Check your wireless card's or adapter's device settings. (Depending on the type of card or adapter you're using, some of the settings may be different than those listed here.) ❏ Set the Network Type to Infrastructure. ❏ Set the SSID to match the name assigned to the access point (which should also match the projector's ESSID). ❏ Make sure Encryption is Disabled if you have not set up encryption on the projector. 6. Click the General tab and make sure that your wireless card or adapter is enabled. 7. When you're done, click OK to close the wireless properties dialog box. 3/08