Epson 6110i Product Information Guide - Page 14

Epson PowerLite 6110i 4. To release the lamp cover, insert the screwdriver included with the new lamp as shown, then remove the cover. 5. Loosen the two screws holding the lamp in place (you can't remove them). 8. Once the lamp is fully inserted, tighten its screws and replace the cover. (The projector won't come on if the lamp cover is loose.) 9. Reset the lamp timer as described in the next section. Resetting the Lamp Timer After you replace the lamp, you need to reset the lamp timer using the projector's menu. 1. Plug the projector in and turn it on. 2. Press the Menu button on the remote control, select Reset Lamp Hours from the Reset menu, then press Enter. Note: The lamp usage timer shows 0H until you've used the lamp for at least 10 hours. 3. When you see the confirmation message, select Yes, then press Enter. 4. When you're finished, press Menu to exit the menu system. 6. Pull the lamp straight out. Transporting the Projector The projector contains many glass and precision parts. Follow these guidelines to prevent injury or damage: ❏ When hand-carrying the projector, you should use the handle to lift it only a short distance (for example, to set it on a table). ❏ When shipping the projector for repairs, use the original packaging material if possible. If you do not have the original packaging, use equivalent materials, placing plenty of cushioning around the projector. ❏ When transporting the projector a long distance, first place it in a hard-shell shipping case, and then pack it in a firm box, placing cushioning around the case. Note: Epson shall not be liable for any damages incurred during transportation. Note: The lamp(s) in this product contain mercury. Please consult your state and local regulations regarding disposal or recycling. Do not put in the trash. 7. Gently insert the new lamp. 14 12/07