Epson ActionPrinter 4500X User Manual - Page 209

Initialization There are two ways that the printer can be initialized (returned to the default settings) through the hardware and one way through the software. These are described in the following table. Hardware initialization Software initialization l The power is turned on. . The printer receives an INIT signal at the parallel interface (pin 31 goes LOW). l The software sends the ESC @ (initialize the printer) command. Default Settings The table below shows the default conditions that become valid when the printer is initialized. Item Reset to: Top of form position Current paper position Left and right margins Cancelled Line spacing 1 1/6-inch line spacing Vertical tab position Cleared Horizontal tab positions Every eight characters VFU channel 1 Channel 0 Font selection Hardware: The current DIP switch setting Software: The current SelecType setting I Condensed mode Hardware: The current DIP switch setting Software: The current SelecType setting Character spacing The current DIP switch setting Justification Left justification Special printing effects Cancelled (except condensed printing) Graphic mode assignment ESCK=ESC*0,ESCL=ESC*1, ESCY=ESC*2,ESCZ=ESC*3 Technical Specifications 8-15